Ameriphone Mobile Sport Massager Operating Instructions Manual - Page 7

Browse online or download pdf Operating Instructions Manual for Telephone Ameriphone Mobile Sport Massager. Ameriphone Mobile Sport Massager 19 pages. Remote control speakerphone

Ameriphone Mobile Sport Massager Operating Instructions Manual
CHAPTER 4
(CONTINUED)
You may set up the DIALOGUE RC in the
following manner to better suit your needs.
Setting the Scan Function
If you have DIALOGUE RC–100:
Only the first six numbers in the memory are
automatically scanned. It stops at each mem-
ory location for 5 seconds to allow you to
select.
To turn scan function off (or on):
1. Press PROGRAM.
2. Press 0 on the keypad to turn it off;
or press 1 key on the keypad to turn it on.
3. Press SCAN button.
If you have DIALOGUE RC–200:
All memory locations with numbers stored are
automatically scanned. The scan rate deter-
mines how long the DIALOGUE RC–200
pauses at each memory location before mov-
ing on to the next one.
To turn scan function on or off:
1. Press
PROGRAM.
2. Using chart, select length of pause
and press the corresponding digit on
keypad.
Length of Pause at Each
Key Entered
VOL
PROG
SCAN
Figure 6
Location in Seconds
Scan Function Off
5
4.5
4
3.5
3
2.5
2
1.5
1
Figure 7
3. Press SCAN
To turn Voice Activation on (or off)
(RC–200 only):
1. Press PROGRAM.
2. Press MUTE button twice. The MUTE
indicator flashes once, and the RC-
200 emits four beeps to confirm that
Voice Activation has been turned on.
3. To turn it off, repeat steps 1 and 2.
This command is confirmed by four
beeps.
To turn the Unanswered Call Indicator
(RC-200) feature off (or on):
1. Press PROGRAM.
2. Press HEADSET button twice.
(Emits four beeps to confirm command).
3. To turn it on again, repeat steps 1
MUT
and 2, and the HEADSET indicator
HEAD
flashes once.
MIC
To turn the Voice Mail Indicator feature
on (or off), (RC–200 only):
1. Press PROGRAM.
2. Press FLASH/PAUSE button twice.
RC–200 emits four beeps and the
FLASH/PAUSE indicator flashes
once.
3. To turn it off again, repeat steps 1
and 2, and the FLASH/PAUSE
indicator does not flash.
To turn the Remote Flash feature on (or
off) (RC–200 only):
1. Slide remote flash switch to "On" (or
"Off") position.
VOL
button.
SCAN
PROG
MUTE
HEADSET
MIC
Figure 8
5