DoorBird A1071 Series Installation Manual - Page 5

Browse online or download pdf Installation Manual for Media Converter DoorBird A1071 Series. DoorBird A1071 Series 12 pages. 2-wire ethernet poe converter

Print Page

STEP 4: RECEIVER INSTALLATION

Place the Receiver at the end of your 2-wire cable ends. Connect the 2-wire

cable coming from the Sender to the Port "1" and "2" of the Receiver. Please

take care of the polarity of the 2-wire cable ("1" and "2"). The port "1" of the

Sender must be connected to the port "1" of the Receiver and the port "2" of

the Sender must be connected to the port "2" of the Receiver.

Now connect a network cable to the RJ45 jack of the Receiver. A Cat.5

network cable with RJ45 plug or better must be used to connect to the

"LAN/PoE" jack of the Receiver.

Connect the spare end of the network cable connected to the Receiver to the

device you would like to establish a PoE and network data connection with, e.g.

an IP Video Door Station or IP Camera.

STEP 5: ACTIVATING THE DEVICES

Switch on the power leading to the assembly location again. Make sure

to switch on power of the PoE-Switch / PoE-Injector you have connected the

Sender to.

The Diagnostic-LEDs of RJ45 jack of the Sender and Receiver should be blinking

and thus signaling an established power- (PoE) and network connection.

Please check the polarity of the 2-wire cable between the Sender and Receiver

and check also your PoE-Switch / PoE-Injector if the Diagnostic- LEDs are

not blinking.

DIAGNOSTIC-LEDS

You can check if the Sender and Receiver are properly connected by checking

the Diagnostic-LEDs. The Diagnostic-LEDs of RJ45 jack of the Sender and

Receiver should be blinking and thus signaling an established power- (PoE)

and network connection.