Doorentryonline SK401-E User Manual - Page 7
Browse online or download pdf User Manual for Keypad Doorentryonline SK401-E. Doorentryonline SK401-E 13 pages. Stand-alone keypad & proximity card reader
Print Page
SET ACCESS CONFIGURATION
• Card or PIN (Default): The User must present a valid card/fob to the SK401-E or enter their PIN code
followed by the # key, in order to be granted access
• Card + PIN: The User must first present a valid card/fob to the SK401-E and then enter their PIN code
followed by the # key, in order to be granted access
Programming Step
1. Enter Program Mode
2. Card or PIN
Relay 1
Relay 2
3. Card + PIN
Relay 1
Relay 2
4. Exit Program Mode
User Settings
To enter the programming mode
To exit from the programming
mode
Note that to undertake the following programming, the Master PIN must be entered
Note:
When adding users, if the card/fob or Pin user has been enrolled already, you cannot add it again on the
same relay, or the device will give a bleep as an error. It is ok to enroll the same card/fob or PIN for both
relay outputs
Factory default setting: Card or PIN mode
To set users for Relay 1. 4
To add PIN users
To delete PIN users
To change the PIN of a PIN user
(Note: This step must be done out of
programming mode)
Keystroke Combination
﹡(Master Code) #
(Default)
4 1 0 #
4 2 0 #
4 1 1 #
4 2 1 #
*
*
Master code
#
*
1
0
#
1
User ID number
The ID number is any number from 1-1000
The PIN is any 4-6 digits between 0000-999999 with the exception of
1234 which is reserved. Users can be added continuously without exiting
programming mode as follows:
1
User ID no 1 #
3
User ID number
Users can be deleted continuously without exiting programming mode
*
ID number #
Old PIN #
#
PIN #
PIN # User ID no 2 #
#
New PIN #
Repeat new PIN #
PIN #