AMERITRON RCS-10 Instruction Manual - Page 8
Browse online or download pdf Instruction Manual for Switch AMERITRON RCS-10. AMERITRON RCS-10 16 pages. Remotec coax switch
Print Page
Ameritron RCS-10
When possible coil all cables near this unit, and always use drip loops. See figure 1.
Connect the lowest and smallest antenna to port one, or short port one and use ports 2-8
for antennas if possible. See the Lightning Protection section of this manual.
Wiring
Wiring is very simple. Be sure any wire you use is suitable for the environment it will be
placed in. Do not bury above-ground rated wires, and do not use indoor non-UV resistant
wires in direct sunlight.
Three insulated wires should connect terminals A, B, and C on the relay box to terminals
A, B, and C on the indoor control head. The ground return can either be made through the
coaxial cable shield, or through additional conductor(s) in the control wire.
We recommend following a standard resistor color code format for wiring. Use brown for
A, red for B, and orange for C if possible. Otherwise, start with the lowest standard color
and work upwards. If you do this with all cables, you will rarely need to keep wiring
notes.
6
DRIP AND LIGHTNING RETARDING LOOPS
THIS LENGTH MAY VARY UP TO
3 FT. IT MUST NOT CONTACT
THE MAST OR TOWER
2 TURNS 6" DIA. ON ALL CABLES
LEAVING AND ENTERING THE
RELAY BOX. KEEP COILS SPACED
FROM EACH OTHER BY VERTICAL
OR HORIZONTAL SEPARATION OF
2" MINIMUM
TAPE TO THE MAST OR TOWER FOR
SUPPORT NEAR THE RELAY BOX
MOUNTING LOCATION
TO ANTENNA
Figure 1
IMPORTANT
NEVER switch antennas with more than 100 watts
RF power applied to the feedline. Damage to the
switching contacts may result from "hot switching."
Instruction Manual