DoorHan SLIDING-800 Installation And Operation Manual - Page 8

Browse online or download pdf Installation And Operation Manual for Garage Door Opener DoorHan SLIDING-800. DoorHan SLIDING-800 12 pages.

Print Page

4.5. Installation of gear rack on third-party door

1. Move the leaf manually in one of its extreme positions.

2. Put the first part of the rack on the gear and install the collar between the rack and the door so that they coincide with the

upper part of the slot.

3. Mark the drilling point on the door. Drill a hole of 6.5 mm and cut the thread using a tap M8. Tighten the bolt.

4. Move the leaf manually so that the rack remains on the gear and repeat step 3.

5. Attach another rack element against the previous one. Align the teeth of these two elements using free rack. Move the door

manually and perform all operations in the same way as for the first element. Repeated as long as the door is not completely

overlapped by racks.

Installation notes for the rack

1. Never weld the racks to the collars or to each other.

2. Check that the door can reach mechanical stops, and there is no friction while moving the door.

3. Do not lubricate any rack or gear.

4.6. Placement of limit switches plates

Sliding-300/800 drive is equipped with ferreed

contacts (magnetic reed switches) that are responsive

to the movement of magnet attached to the rack and

generate a command to stop the door.

Install the limit magnets as follows.

1. Release the drive (see sec. "Release mechanism

operation").

2. Move the door manually to the opened position with

2-5 cm to the mechanical stop

3. Move the magnet of limit switch to open (triangular blue sticker) along the rack in the direction of door opening until magnetic

reed switch is OFF. This can be seen by looking at the corresponding LED on the control board (see sec. "Control unit LEDs").

Slide the magnet in the same direction for approximately 2-3 cm and secure it to the rack.

4. Move the door to the closed position with 2-5 cm to the mechanical stop.

5. Move the magnet of limit switch to close (round red sticker) along the rack in the direction of door closing until magnetic reed

switch is OFF. This can be seen at the appropriate LED on the control board (see sec. "Control unit LEDs"). Slide the magnet

in the same direction for approximately 2-3 cm and secure it to the rack.

6. Move the door to the middle position and lock the drive (see sec. "Release mechanism operation").

7. Provide at least 2 cm gap from the door to the mechanical stop in the extreme opened and closed positions to ensure quality

operation of the system.

8. Run several complete cycles of operation and verify the installation of limit switches. The drive shall stop upon reaching the

limit switch with the corresponding LED goes out. SW1— LED for switch to close. SE2 — LED for switch to open.

9. Distance from the limit switch to limit switch magnet shall be not more than 5 mm.

WARNING! Upon adjustment of limit positions, make sure of normal operation of limit switches: the corresponding LED

on the control unit shall go out upon response. If the light does not go out, repeat the adjustment.

Door leaf

Полотно ворот

Gear rack

Зубчатая рейка

Installation base

Монтажное основание

blue

синий

Limit switch to open

DRIVE ASSEMBLY

red

красный

Limit switch to close