DABmotion AN3012DAB Installation Manual - Page 7

Browse online or download pdf Installation Manual for Antenna DABmotion AN3012DAB. DABmotion AN3012DAB 8 pages. Glass-mount dab antenna

Print Page

AN3012DAB Installation Guide

fiber; also peel off a small portion of the adhesive separator on the Copper

Strip. Then, press and bond the Signal Booster to the marked location

from pre-installation and on the inside of the front windshield. Ensure that

the Signal Booster, Copper Strip, and Antenna are not distorted.

➋

Attach the Copper Strip

Gently peel off the rest of adhesive separator of the Copper Strip and

paste it across the windshield to the metal frame of the A Pillar, press and

smooth out the Copper Strip. Secure the Copper Strip, with the supplied

3M tape, on to the metal windshield frame.

➌

Attach the Antenna

Gently peel off the rest of adhesive separator of the Antenna and paste it

on the inside of the front windshield. While pressing and smooth out

the Antenna to the glass, take precaution that you do not over press

the joint, between the Antenna and the Signal Booster.

➍

Secure the Coaxial Cable

Secure the coaxial cable tightly against windshield, then tightly against

and diagonally across to the metal frame of the A-Pillar with the supplied

3M tapes. Securing the coaxial cable this way avoids the A pillar

damaging the antenna cable and affecting performance.

➎

Secure Junction Box

Secure the Junction Box with the supplied 3M tape on the metal frame.

➏

Secure the Antenna Cable

Secure the antenna cable tightly down on the metal frame of the A-Pillar

with the supplied 3M tape.

 Re-attach A Pillar cover

Re-attach the A Pillar cover, with the antenna cable runs out of bottom of the

cover.



Route the antenna cable

Route the antenna cable from the bottom of the A-Pillar cover within the car

interior to the DAB receiver, make sure the antenna cable does not interfere

with the safe operation of steering wheel, air bags, and seatbelts or other

equipment.



Connect to the DAB receiver

a. Power off the DAB receiver.

b. Plug the Antenna Connector at the end of the antenna cable into DAB

receiver's antenna input connector.

c. Power on the DAB receiver and start using your DAB receiver with the

DAB antenna.

Note:

To achieve the best performance, Antenna must not be placed over a UV

protection layer.

-5-