DoorHan PCB-SH380 Quick Start Manual - Page 7
Browse online or download pdf Quick Start Manual for Controller DoorHan PCB-SH380. DoorHan PCB-SH380 8 pages. Control board
3. TRANSMITTER PROGRAMMING
3.1. RECEIVER MEMORY CLEARING
After power supply is switched on, press and hold the transmitter programming button «R» for about 20 seconds. After the
time expires, the indicator «R» will light up for about a second to confirm that all the transmitters have been erased from the
memory.
3.2. TRANSMITTERS RECORDING
To record a transmitter press and hold the «R» button for 3 seconds till the «R» indicator lights up. Release the «R» button.
Choose the button on the transmitter that you wish to operate the operator. Press it twice, «R» indicator will go out to confirm the
transmitter code has been recorded in the receiver.
NOTE. When memory is full, the «R» indicator flashes three times (maximum number of transmitters in the receiver
memory is 60 pcs.). To program several transmitters repeat the programming procedure for each transmitter.
3.3. REMOVING A TRANSMITTER FROM THE RECEIVER MEMORY
To deactivate any unwanted transmitter press and hold the «R» button until the «R» indicator starts to blink (approximately
13 seconds). Then press twice the recorded button of the transmitter you want to delete from the receiver memory. Indicator «R»
will go out.
NOTE. To remove several transmitters, repeat the procedure for each transmitter.
3.4. REMOTE PROGRAMMING OF TRANSMITTERS
Perform steps 1–4 within a 5-seconds interval:
1. Press and hold button 2 of the programmed transmitter.
2. While holding the button 2, press and hold the button 1.
3. Release all pressed buttons.
4. Press the programmed transmitter button; the receiver will enter the transmitter programming mode (the «R» indicator
will light steadily).
5. On new transmitter press twice the button, that you wish to operate the operator. The «R» indicator will flash once to
confirm the transmitter code has been programmed in the receiver.
NOTE. Perform transmitter programming within the receiver working range. The button number can be determined by
the dots on the transmitter body.
3.5. DISABLING REMOTE PROGRAMMING OF TRANSMITTERS
If the function is enabled, when power is supplied to the board, the «R» indicator lights up and go out for a short time. If the
function is disabled, when power is supplied to the board, the «R» indicator does not light up. To disable / enable the function,
press and hold the «R» button, then, without releasing the button, supply power to the board.
1
2
TRANSMITTER PROGRAMMING
1
3
4
2
7