Canon PIXMA MP499 Network Setup Manual - Page 9
Browse online or download pdf Network Setup Manual for All in One Printer Canon PIXMA MP499. Canon PIXMA MP499 24 pages. Obtaining network key
Also for Canon PIXMA MP499: Network Installation Manual (17 pages), Network Manual (22 pages), Network Manual (16 pages), Manual (13 pages), Manual (10 pages)
Print Page
- 1. Table of Contents
- 2. The Target Access Point Is Not Displayed (Detected) on the Detected Access Points
- 3. Set Printer Ip Address Screen Is Displayed
- 4. The Machine Is Not Displayed (Detected) on the Detected Printers List Screen
- 5. Problems During Network Setup
- 6. Configuring Wireless Lan Settings Manually
- 7. Other Troubleshooting Tips
- 8. Restoring the Machine's Default Lan Settings to Perform Setup Again
Other Troubleshooting Tips
Forgotten or Do Not Know the Access Point Name/Network Name
(SSID), Security Protocol (encryption standard), and Network Key
Check
Check the access point settings.
•
For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
The Machine is Not Detected after the Network Environment is Changed
Check
Wait until the IP address is assigned to the computer. You may need to restart your
computer.
•
Search for the machine again after confirming a valid IP address is assigned to the computer.
Glossary
•
IP address
A numerical identification assigned to each computer or network device connected to a network.
Reference Information
Configuring Wireless LAN Settings Manually
Action
Enter the access point name/network name (SSID) and security setting (WEP, WPA,
etc.) directly.
Follow the procedure below.
1
Perform
to
in "Software Installation (1)" in the printed manual: Getting Started.
•
If the Detected Access Points List screen is displayed, go to .
2
When the Confirm Connection Access
Point screen appears, click No (A).
•
The Detected Access Points List screen is
displayed.
3
Click Manual Setup (B).
•
The Manual Setup screen is displayed.
4
Enter the access point name/network name
(SSID) in SSID (C).
5
Select the security protocol for the access
point in Encryption Method (D), then click
Configuration (E).
•
Go to either of the following steps according
to the selected Encryption Method (security
protocol).
Disable
Go to
WEP
Go to
WPA/WPA2
Go to
A
B
C
D
on page 9.
on page 9.
on page 9.
E