Canon PIXMA MX340 Series Simplified Service Manual - Page 6

Browse online or download pdf Simplified Service Manual for All in One Printer Canon PIXMA MX340 Series. Canon PIXMA MX340 Series 35 pages. Cartridge reset
Also for Canon PIXMA MX340 Series: Installation Manual (17 pages), Install Manual (11 pages), Network Setup Manual (26 pages), Brochure (2 pages), Manual (8 pages), Manual (10 pages), Network Setup Troubleshooting (13 pages), Network Installation Manual (16 pages), Connection Manual (11 pages), Manual (4 pages)

Print Page
Canon PIXMA MX340 Series Simplified Service Manual
1-2. Service Call Errors (by Cyclic Blinking of Alarm and Power Lamps)
Cycles of
blinking of
Error
Alarm and
Power LEDs
2 times
Carriage error
3 times
Line feed error
5 times
ASF cam sensor
error
6 times
Internal
temperature
error
7 times
Ink absorber full [5B00] The ink absorber is
8 times
Print head
temperature rise
error
9 times
EEPROM error
Error
Conditions
code
[5100]
An error occurred in the
carriage encoder signal.
[6000]
An error occurred in the LF
encoder signal.
[5700]
An error occurred in the
ASF cam sensor (during
paper feeding from the rear
tray).
[5400]
The internal temperature is
not normal.
supposed to be full.
[5200]
The print head temperature
exceeded the specified
value.
[6800]
A problem occurred in
[6801]
reading from or writing to
the EEPROM.
(5/37)
Solution
(Check points and replacement items)
1) Smearing or scratches on the timing
slit film;
clean the timing slit film.
2) Foreign material or paper debris that
obstructs the carriage movement;
remove foreign material.
3) Ink cartridge conditions;
reseat the ink cartridges.
4) Cable connection
5) Part replacement:
- Timing slit film
- Carriage unit
- Logic board
1) Smearing or scratches on the LF
encoder;
clean the LF encoder.
2) Foreign material or paper debris in the
LF drive;
remove foreign material.
3) Cable connection
4) Part replacement:
- LF encoder
- Logic board
1) Cable connection
2) Part replacement:
- PE PWB unit
- Drive unit
- Logic board
1) Cable connection
2) Part replacement:
- Logic board
- Ink cartridge
1) Ink absorber condition
2) Part replacement:
- Ink absorber kit
3) Ink absorber counter value in the
EEPROM;
reset the ink absorber counter.
1) Ink cartridge conditions
2) Cable connection
3) Part replacement:
- Ink cartridge
- Logic board
1) Part replacement:
- Logic board