DoorKing 1800-500 Quick Start Manual - Page 3

Browse online or download pdf Quick Start Manual for Controller DoorKing 1800-500. DoorKing 1800-500 9 pages. Dks smart gate controller

Print Page

Install your DKS Smart Gate Controller

The DKS Smart Gate Controller's signal is impeded by metal. Make sure that the place where you are installing it has a strong

Wi-Fi signal (see previous page "Preparation Before Installation").

The operator cover can also diminish the signal. If the controller is being installed INSIDE the operator, test it with the operator

cover on and see if signal strength is acceptable.

NOTE: In the app, you can check wireless signal strength, "Check Device Network"

DoorKing's recommendation is 67dbm or below. The cell phone must be connected to same

Wi-Fi as the DKS Smart Gate Controller.

If the controller is installed OUTSIDE the operator, make sure to use a waterproof plastic box

(not provided) to protect the controller.

After you are satisfied with the Wi-Fi signal strength in the location where you are installing your

DKS Smart Gate Controller, find your specific DoorKing operator on the next 2 pages to show

how to wire the controller to it.

POWER OFF your existing gate operator BEFORE installation

Kit Includes:

ON / OFF

Switch

LED

Relay

Output

Yellow

Relay

Contact

Blue

Tesa Tape

Optional Magnetic Sensor

DoorKing advises to use the built-in relay on every DKS operator circuit board to control this function instead of the magnetic

sensor in this kit. If NOT using the built-in relay on the DKS operator circuit board, the magnetic sensor can be used instead.

Connect the magnetic sensor plug to the BLUE wires plug connecter inside DKS smart gate controller.

IMPORTANT

The magnetic sensor needs to be 1/4" or less to function. Shims may need to be used to allow the sensors to

remain close enough to activate.

if needed

(not provided)

Power _

Black -

Red +

1/4" or less

Shim

Sensor Plug

Waterproof Enclosure

Cable Clip

Holders

Zip Ties

Magnetic Sensor (Optional)

Remove Blue

Wires Plug,

Replace with

Sensor Plug

u t

I n p

(not provided)

Sensor

Mounting Brackets

Nail Wire Clips / Screws / Bolts & Nuts

Remove Output Cover

1800-065-B-9-23