Canon PIXMA MX870 Series Network Setup Manual - Page 4

Browse online or download pdf Network Setup Manual for All in One Printer Canon PIXMA MX870 Series. Canon PIXMA MX870 Series 34 pages. Setting up in default mode (tel priority mode) without an answering machine
Also for Canon PIXMA MX870 Series: Installation Manual (17 pages), Install Manual (11 pages), Network Setup Manual (16 pages), Brochure (2 pages), Network Installation Manual (24 pages), Network Installation Manual (17 pages), Setup Manual (15 pages), Setting Up (15 pages)

Canon PIXMA MX870 Series Network Setup Manual
Check 5
Is "WPA/WPA2 Enterprise" set as a security protocol (encryption standard) on the
access point?
"WPA/WPA2 Enterprise" is not supported on the machine.
Change the security protocol (encryption standard) for the access point, then configure
settings again.
For details on how to change the security protocol (encryption standard) for the access point,
refer to the manual supplied with the access point or contact its manufacturer.
For the procedure to configure settings of the machine, refer to "Wireless Setup Using Easy
Setup" in the printed manual: Getting Started.
Glossary
SSID
An identifier to identify the specific access point.
SSID broadcast
An access point's periodic transmission of a signal revealing its SSID.
Stealth mode
A function to prevent the SSID of the access point from appearing on other wireless devices.
MAC address
A unique number assigned to each network device.
MAC address filtering
A function to block access from unauthorized wireless devices by saving the MAC addresses of specific
wireless devices (computers, printers, etc.) to the access point beforehand.

Access point was not detected. is Displayed

Check
The message appears when no access point is found.
Refer to "The Target Access Point is Not Displayed
(Detected)" on page 2.

Failed to connect to the access point. is Displayed

Check
Check 1
Is WEP key number 2, 3 or 4 of the access point in use?
For details on how to check the WEP key number of the access
point, refer to the manual supplied with the access point or
contact its manufacturer.
Set to use WEP key number 1 of the access point, or select a WEP key number by
entering wireless connection settings of the machine directly.
For details on how to change the WEP key number of the access point, refer to the manual
supplied with the access point or contact its manufacturer.
For details on how to select a WEP key number by entering wireless connection settings of the
machine directly, refer to "Entering the Access Point's Wireless LAN Settings Directly on the
Machine" on page 11.