Doortec DOORMAN SDO1 Installation & Owner's Manual - Page 7

Browse online or download pdf Installation & Owner's Manual for Door Opening System Doortec DOORMAN SDO1. Doortec DOORMAN SDO1 8 pages.

Print Page

6.5

Press and hold SET, the unit displays " 3 ".

6.5.1

Press SET once again, it will show the current setting.

Press UP to increase the force by one degree or press

6.5.2

DOWN to decrease by one degree. Maximum degree is

" 9 ", minimum is " 1 ".

Press SET to confirm. The default setting is " 5 ".

6.5.3

After finishing all the settings, please check the force to

6.5.4

make sure of settings.

6.6

Press and hold SET, the unit displays " 4 ".

6.6.1

Press SET to show current setting. Press UP, it displays

" 1 ", lockout function enabled or press DOWN, It displays

6.6.2

" 0 ", lockout function disabled. Press SET to confirm the

function you require.

When using uncovered transmitters, it is recommended

using the lockout function. This function works when the

6.6.3

door reaches the closed position, you can't open the door

until "lockout" has been disabled first.

6.7

Press and hold DOWN, the unit displays " - " .

6.7.1

Press SET to show current setting. Press UP once the

unit displays " H ", the photo beam is enabled. Press

6.7.2

down once, the unit displays " II ", the photo beam is

disabled. Press SET to confirm required setting and quit.

If you do not make use of the photo beam device,

please make sure it displays " II " , to disable this

6.7.3

function.

6.8

6.8.1

Press and hold UP, the unit displays " - ".

Press SET to show current setting. Press UP to increase

the auto-close time by one minute or press DOWN to

6.8.2

decrease by one minute. Maximum time is " 9 " , minimum

is " 0 ". Press SET to confirm.

The default setting is " 0 ",

close off. This function works when the door

6.8.3

reaches the fully open position.

Force Adjustments

Holiday Lockout – not recommended

Photo Beam

Auto-Close ON/OFF

" 0 "

shows auto-