Astralpool QB800 Owner's Manual - Page 9
Browse online or download pdf Owner's Manual for Swimming Pool Vacuum Astralpool QB800. Astralpool QB800 16 pages. Robotic pool cleaner
Also for Astralpool QB800: Owner's Manual (16 pages)
QB800 robotic cleaner
•
Do not leave your cleaner in the pool on a
permanent basis.
•
At the end of each cleaning cycle, remove the
cleaner from the pool.
•
Start at the cleaner head and untangle any coils in
the cable before storing the cleaner.
The robotic cleaner includes a safety feature that
automatically stops the cleaner if it is powered on but
not submerged in water. For pools equipped with a
beach area, this safety feature is programmed to drive
the cleaner in reverse and back into the pool when the
impeller is out of the water.
AstralPool recommends not exceeding 3 cleaning
cycles per week.
4.1
Install and Submerge the Cleaner
1.
With the control box plugged into a power outlet,
spread the fl oating cable across the pool deck until
you reach the middle of the pool length.
2.
At the center point, submerge the cleaner in the pool
and hold in the vertical position to release any air
trapped inside.
Figure 11. Submerge Cleaner Vertically
3.
Ensure the unit sinks to the bottom of the pool and
does not fl oat.
Figure 12. Sink Cleaner to the Bottom of the Pool
Owner's Manual
4.
Place only enough fl oating cable in the water to reach
the farthest end of your pool from the central point.
Spread out the fl oating cable ensuring there are no
kinks or coils in the cable.
cleaner
cleaner
Max
Floating Cable
Length
Figure 13. Pool Entry Point for Optimal Patterning
4.2
Cleaner Control Unit
The control unit can be used to initiate all basic
cleaning features.
9
Not
Recommended
caddy /
control unit
Recommended
entry point
WARNING: Do not use
an extension cord