Astralpool QG50 Owner's Manual - Page 7

Browse online or download pdf Owner's Manual for Swimming Pool Vacuum Astralpool QG50. Astralpool QG50 16 pages. Robotic pool cleaner

Astralpool QG50 Owner's Manual
QG50 robotic cleaner
2.
Press control unit onto the caddy hook until it snaps
and locks into position.
Figure 9.
Attach the Control Unit onto Caddy
3.4

Connect to a Power Source

WARNING
Failure to comply with the following warnings
can increase risk of fire or electrocution which
can result in property damage and serious
injury, including loss of life.
PREVENT ELECTRICAL SHOCK
• Keep the control unit at least 3.5 m from the
edge of the pool.
• The cleaner is to be installed in accordance
with the relevant requirements of the Austra-
lian wiring rules AS/NZS 3000. Also refer to the
installation instructions relating to the swimming
pool equipment for which the cleaner will be
an integral part. The cleaner is to be supplied
through a Residual Current Device (RCD) with a
rated residual operating current of 30mA.
• Do not use an extension cord to connect the
control unit.
• Do not allow anyone to swim while the cleaner
is in the pool.
• The control unit is water-resistant, not
waterproof. In order to prevent electrocution,
never submerge the control unit or leave
exposed to inclement weather.
owner's Manual
1.
Unscrew the protective cap for the floating cable
from the side of the control unit by turning counter-
clockwise (Figure 10).
Figure 10. Remove Protective Cap
2.
Align the notch in the floating cable connector with
the key in the control unit, engage then turn clockwise
to tighten (Figure 11).
Figure 11. Connect Floating Cable
3.
Plug the control unit directly into a GFCI outlet. DO
NOT use an extension cord.
NOTE: To avoid damaging the power cable, do not try to
twist the entire cable housing (see below).
NOTE: To avoid exposing the power cable connector pins
to water, be sure the connector is screwed in all the
way and there is no gap. (see below).
7
Align:
Key with Notch