Amerlux GRUV 1.5” Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Lighting Equipment Amerlux GRUV 1.5”. Amerlux GRUV 1.5” 3 pages. Led, gypsum board

Print Page
Assembling Continuous Rows
Housing Assembly
Refl ector Removal (only required to access driver)
WARNING: Electrostatic and polarity sensitive device. Use caution while handling and wiring.
WARNING: Electrostatic and polarity sensitive device. Use caution while handling and wiring.
1.) LED Fixture:
1.) LED Fixture:
Consult Amerlux for LED maintenance.
2.) LED Replacement:
2.) LED Replacement:
For LED board replacement reference 689-0500 Instruction Sheet.
3.) Driver maintenance:
3.) Driver maintenance:
Drivers are located on tray beneath direct refl ectors, (1) driver per tray, secured by (2)
#8 pal nuts. Remove the refl ector mounting screws to access. For programmable driver
replacement please specify: Manufacturer, Model No. and Current Setting (_____ mA)
drivers with external
external resistors, keep driver resistor value during driver maintenance or
replacement.
See 710-0134 Wiring Schematic for more details.
MAKE SURE TO DISCONNECT ALL ELECTRICAL CONNECTIONS BEFORE ACCESSING LED
MAKE SURE TO DISCONNECT ALL ELECTRICAL CONNECTIONS BEFORE ACCESSING LED
LLC | 178 Bauer Drive, Oakland, NJ 07436 | p: 973-882-5010 f: 973-882-2605 | www.amerlux.com
®
Amerlux
Joining the Housings
Joining the Housings
Line up the two housings by using the
alignment splines. Secure them
together by using the Catch and Latch
System on the top of the extrusion.
Manufacturer, Model No. and Current Setting (_____ mA). For
INSTALLATION INSTRUCTIONS
GRUV 1.5"
LED, Gypsum Board
Catch and
Latch
Alignment Spline
and/or Pins
689-0512
pg 2 of 3
Driver tray
#8 pal nut
AMX P/N 625-0059
(2) per driver
Driver
Refl ector
#4-40 self-tap screws
AMX P/N 622-2019
(4) per refl ector
Snap-in lens