AmerTac Westek TMMW25 Instructions

Browse online or download pdf Instructions for Timer AmerTac Westek TMMW25. AmerTac Westek TMMW25 2 pages. Mechanical wall switch timer

Print Page

Mechanical Wall Switch Timer Instructions

• 24 hour on/off timer. Up to 24 ON and 24 OFF settings in a 24 hour period.

• 1 pin = 30 minutes

• Easy to install in a standard 2-1/2 inch vertically installed junction box

replacing a standard single pole single throw wall switch.

INSTALLATION

1. Turn off power to the branch circuit at the circuit breaker.

2. Remove the existing switch.

3. Using the wire nuts provided connect the wires of the timer and wall

box as instructed below. (See wiring schematic)

3.1 Connect the HOT/Live of the branch circuit (Black) to the black

wire from the timer.

3.2 Connect the Neutral wires of the branch circuit and load from

the box (white) to the white wire from the timer.

3.3 Connect the HOT/Live wire of the load to the red wire from the

timer.

3.4 Ground wire is not required for this timer because the cover is

non conductive.

Note: Be sure all wire nut connections are secure.

4. Tuck the wires into the wall box leaving room for the timer

5. Using the screws provided, mount the timer to the wall box being

careful not to crush any wires.

Timer lock and switch insert

The TMMW25 is provided with 2 inserts to allow the timer to be locked

in timer mode or used with "ON/OFF/TIMER" switch.

The switch cover allows the switch to be moved to select the "TIMER",

"OFF" or "ON" modes. The TIMER LOCK insert locks the switch in the

"TIMER" mode and will not allow the switch to be changed without

replacing the insert.

Select the desired insert and place it in the cover plate before attaching

to the installed timer.

Timer operation:

Setting ON / OFF Periods

This timer can be programmed with up to 24 on and 24 off settings in

a twenty-four hour time period. There are 2 pins (30 Minutes each)

associated with each hour in the day. Using your finger, a pen, or a

screwdriver, pull up (OFF) all pins corresponding to the times you want

the timer to turn power off to the load. For desired "ON" times, make

sure the pins are pushed down. The pins are typically set to the "ON"

position when you open the package.

Setting time of day

Turn outer dial clockwise until triangular pointer is lined up with the

present time of day. Be sure switch is set to "TIMER".

Caution: Turning dial counter clockwise will damage the unit causing it

to stop working.

Selecting Mode: ON / OFF / TIMER

If you want the timer to run the ON / OFF programs as you set them in

previous section, you must select "TIMER" mode on the switch below

the dial. Programmed ON / OFF times can be interrupted by using the

"ON /OFF/ TIMER" switch located just below the dial. After placing the

switch in the OFF or ON Position the controlled device will stay OFF or

ON untiI the switch is manually changed. If the "Timer Lock" is

installed, the switch is forced into the TIMER mode and cannot be

changed until the lock is removed. This feature is best utilized in public

locations where you don't want someone overriding the timer settings

and turning a device on/off for extended periods of time.

Caution:

For indoor Use only

Do not use with any appliance that exceeds the capacity of the

timer.

Fan heaters and heaters with exposed elements should not be

connected to timers.

Wallbox

Boîtier

Caja de pared

Timer

Minuterie

Temporizador

Black

Red

Timer

Light

120 AC

Power In

White

Timer is non metal construction so no ground

wire is required for timer housing

Typical wiring schematic

Questions, ¿Preguntas?, Questions? 201-661-9945

Saddle River Executive Centre

One Route 17 South, Saddle River, NJ 07458

www.amertac.com

Made in China/Fabriqué en Chine/ Hecho en China

I13-0004-A

TMMW25

Front Cover

Couvercle avant

Cubierta frontal

Use one or the other

Utiliser l'un ou l'autre

Utilice uno de los dos

Timer Lock

Switch cover (optional)

(optional)

Couvercle de l'interrupteur

Dispositif de

(optionnel)

verrouillage

Cubierta del interruptor

de la minuterie

(opcional)

(optionnel)

Bloqueo del

temporizador

(opcional)

Black

1 Year Limited Warranty

AmerTac warrants to the original

purchaser that this product will be

free from defects in materials and

White

workmanship for a period of 1 year

from the date of purchase. Additional

details are available at

www.amertac.com. PROP. 65

WARNING: This product contains

chemicals known to the State of

California to cause cancer, birth

defects or other reproductive harm.