Flybar 1752490 User Manual - Page 5

Browse online or download pdf User Manual for Motorized Toy Car Flybar 1752490. Flybar 1752490 13 pages. 12v ride on bumper car

Print Page

Power On/Off/Speed switch

BEFORE USE

• Remove the two screws from the seat cover and lift out the cover.

• Connect the battery terminal. You must connect the same color wires together: black

connector to the black terminal, red terminal to the red connector. Make sure they are

connected with the correct polarity.

• Replace the seat cover with the two screws and tighten.

• Plug the charger into a standard 120v wall outlet and the

wire end into the charger port.

• Fully charge the battery for 8-12 hours.

•

Do not charge the battery for more than 12 hours.

• Check the battery and charger for any signs of wear or damage

before use and do not use if damaged.

• Press the power switch down or up to turn the vehicle on. Note, down position (-) is

low speed. Upward postion (=) is high speed.

• Bumper car is equiped with slow start function for safety. When starting out bumper

car will take 4 seconds to get up to full speed.

• Push or pull the control joysticks to move the vehicle

• Release both control joysticks to stop the vehicle completely

WARNING: Close supervision is required when child is operating the vehicle.

Flybar_V1_12V_Bumper_car_manual_Costco_USA.indd 5

USER INSTRUCTIONS

High-speed

Off

Low Speed

Charging

port

7/13/23 10:35 AM