AMES 64021 Owner's Manual & Safety Instructions - Page 11
Browse online or download pdf Owner's Manual & Safety Instructions for Multimeter AMES 64021. AMES 64021 16 pages. Professional, commercial & residential digital multimeter
temperature Measurement
Measure temperature from -40
1.
Connect red (+) end of Thermocouple
(included) to the
Jack and the black (-) end to
the
input Jack.
mAμA
2.
Turn Rotary Switch to the °c°F
position. The Display will show the
current ambient temperature.
3.
Press Blue Button to switch
between Celsius and Fahrenheit.
4.
Touch the tip of the Thermocouple
to the object being tested.
resistance Measurement
Measure resistance up to 60M Ohms.
WarninG! to prevent electric shock,
turn off all power and fully
discharge capacitors in the circuit
under test before measuring.
note: When measuring Ohms,
start with the lowest range if the
resistance is unknown.
1.
Plug black test lead into cOM Jack.
Plug red test lead into
VΩHz input Jack.
2.
Turn the Rotary Switch to
the
position.
3.
Press Blue Button until the Display
indicates Ohms Ω is being measured.
4.
Carefully touch exposed
conductors with tips of probes.
5.
Read measured resistance
on the Display.
Item 64021
F to 1832
°
°
VΩHz input
For technical questions, please call 1-888-866-5797.
F (-40
C to 1000
C).
°
°
5.
After a few seconds the measured
temperature will display.
6.
When testing is complete, turn
Rotary Switch to OFF, remove
Thermocouple and store with Meter.
note: To avoid measurement errors at
very low temperatures, the operating
temperature must not exceed 10~28°F.
WarninG! to prevent electric
shock, remove thermocouple before
switching between testing modes.
6.
When testing is complete, turn
Rotary Switch to OFF, remove
Test Leads and store with Meter.
note: Sometimes the resistor value and
measured resistance differ. This is due
to the Meter's output test current going
through all possible paths between leads.
• Keep test leads as
short as possible.
• Resistors should be
measured out of circuit.
note: For resistance measurements
above 1MΩ, allow a few seconds
to get a steady reading.
note: When leads are disconnected
or measurement is out of
range, OL is displayed.
Page 11