Ames Instruments 64013 Owner's Manual & Safety Instructions - Page 4
Browse online or download pdf Owner's Manual & Safety Instructions for Measuring Instruments Ames Instruments 64013. Ames Instruments 64013 16 pages. Digital clamp meter. ac 600v cat iii
14. Do not operate Meter if under the
influence of alcohol or drugs. Read
warning labels on prescriptions to
determine if your judgment or reflexes
are impaired while taking drugs. If there
is any doubt, do not operate the Meter.
15. People with pacemakers should
consult their physician(s) before
use. Electromagnetic fields in close
proximity to heart pacemaker could
cause pacemaker interference
or pacemaker failure.
16. Do not test voltage on circuits
higher than 600 volts.
17. Do not test current on circuits
higher than 600A.
18. Dress properly. Protective,
electrically nonconductive
clothes and nonskid footwear are
recommended when working.
19. Wear ANSI-approved safety
goggles during use.
20. Only use accessories intended
for use with this Meter.
21. Avoid damaging Meter. Use only
as specified in this manual.
22. Prior to testing resistance, diodes,
or continuity; disconnect all power
to the circuit and discharge all
high-voltage capacitors.
Page 4
SAVE THESE INSTRUcTIONS.
For technical questions, please call 1-888-866-5797.
23. Performance of this Meter may vary
depending on battery condition.
24. Use the proper settings, terminals,
techniques, and range for the
tests performed. Start with the
range stated in the instructions.
25. Do not apply voltage to the Test
Leads when the Meter is in the
Ohms testing setting. Damage
can occur to the Meter.
26. Do not switch between testing modes
with the Meter connected to a circuit.
27. Do not use the Meter at a setting
marked as blank on the scale.
28. Have the Meter calibrated by a
qualified technician every year
to maintain accurate results.
29. Do not disassemble Meter; take
it to a qualified technician when
service or repair is required.
30. The warnings, cautions, and
instructions discussed in this
instruction manual cannot cover all
possible conditions and situations
that may occur. It must be understood
by the operator that common sense
and caution are factors which cannot
be built into this product, but must
be supplied by the operator.
Item 64013