Astria Fireplaces Atlas36ZP2 Installation And Operation Instructions Manual - Page 13

Browse online or download pdf Installation And Operation Instructions Manual for Indoor Fireplace Astria Fireplaces Atlas36ZP2. Astria Fireplaces Atlas36ZP2 20 pages. 36" x 24", 36" x 28" & 42" x 28" universal vent-free fireboxes

Print Page

Installation Instructions -

FBK-100 or FBK 200 Blower Kits and JBK Junction Box Kit

IMPORTANT

All electrical wiring must be performed by licensed Elec-

tricians. Electrical wiring must comply with the National

Electrical Code ANSI/ NFPA 70 - latest edition

Step 1. Follow the instructions below for the model you are installing:

Atlas36ZP2, Atlas36ZP3, Atlas42ZP2 and Atlas42ZP3:

Lift out the bottom refractory panel (see Figure 16).

Step 2. Remove the rectangular knock-out (for J-Box) on the right side

of unit (see Figure 7 for location). Install the Junction Box & Electrical

outlet below the firebox floor into the rectangular opening on the right side

cabinet panel where you removed the knock-out (see Figures 18 and 19).

• Squeeze the J-Box flanges together to fit into the opening shown in

Figures 18 and 19.

• Wires will need to be passed through the hole shown in Figure 17.

• An approved strain relief bushing (not supplied with the kit), is required

to restrain the wires (see Figure 17).

Step 3. Loosely tie a knot in the power cord to take up slack (see Figure 20).

Step 4. Locate the tabs shown in Figure 21. Position the blower assembly

so that the tabs (located on the cabinet base) are seated in the notches of

the blower bracket. Bend the tabs over to secure the blower assembly (see

Figure 22).

Step 5. Plug power cord into the electrical outlet as illustrated in Figure 14.

Lift Out Bottom Refractory Panel

Models: Atlas36ZP2,

Atlas36ZP3, Atlas42ZP2

and Atlas42ZP3

Figure 16

SINGLE -PERSON LIFT COULD

USE ASSISTANCE WHEN MOVING

Models

WARNING

LIFTING HAZARD

CAUSE INJURY.

OR LIFTING.

NOTE: DIAGRAMS & ILLUSTRATION ARE NOT TO SCALE.

Cover Plate

Remove knock-out

(strain relief bush-

ing [not supplied]

presses into this

hole around romex

wires - see Step 8 on

Page 14).

Screw

Figure 17 -

Junction Box Kit (all models)

J-Box & Electrical Outlet

Firebox

floor

Install into side wall rectanular opening

Figure 18 -

Model

Atlas42ZP2 Shown

Right Outside Cabinet Panel

J-Box Flanges

Wires

Figure 19

J-Box &

Receptacle

J-Box Flange

J-Box &

Electrical

Outlet