Akw 30503 Installation Instructions Manual - Page 6

Browse online or download pdf Installation Instructions Manual for Bathroom Fixtures Akw 30503. Akw 30503 16 pages. Bidet

Print Page

Important Information

CAUTION

•

only connect to the mains cold water supply and test the water supply pressure. Depending

on the water pressure to the installation, the aKw Bidet will need to be adjusted to operate

at that pressure. See water pressure Mode setting, page 6 in the user manual.

•

after the installation, make sure to check all water supply connections for leaks.

Rubber washers should be in place for the water connection hoses and tee junction.

•

Do not open/close the seat/seat lid cover using excessive force.

•

Ensure that the user is familiar with the operation of the bidet and leave the user manual

with the owner.

•

Exercise caution that urine does not come into contact with the warm air dryer outlet. failure

to do so may result in bad odours or malfunction.

•

Do not tilt or turn the bidet upside down if there is any water in the tank. See page 15.

•

If the appliance is not to be used for a long period of time (more than a few weeks), switch off

the appliance at the mains, isolate the water supply and drain the heater tank. See page 15.

•

when this appliance has reached the end of its serviceable life, it should be disposed of in

a safe manner in accordance with current local authority recycling or waste disposal policy.

These instructions are provided to advise the minimum standards of installation and recommends what the

best practice for the installation is. Due to the very wide variability of possible installation conditions, AKW cannot

provide all circumstances for the installation. AKW cannot accept any liability in connection with this information

or its use. This information is provided on the condition that the person receiving it shall make their own tests to

determine the suitability for the particular purpose. Failure to install this AKW product in accordance with supplied

instructions or the making of unauthorised modifications will invalidate any warranty and may affect product

safety.

None of the foregoing affects your statutory rights.

General: 01905 823 298