ASTRO U 100-230 Operating Manual - Page 9

Browse online or download pdf Operating Manual for Media Converter ASTRO U 100-230. ASTRO U 100-230 16 pages. Base unit
Also for ASTRO U 100-230: Operating Manual (8 pages)

Print Page

1. Technical Data

Connecting and installing modules

[1, 2] Phillips-head screws

[3] Cable for signal supply

[4] Cable for power supply

Operating Manual U 100-230 and U 100-48 -

To prepare the backplane for installation, proceed as follows:

Plug the bridge into the installation position provided in accordance with figure 3

(page 8).

NOTE

A bridge which has not been correctly plugged into the corresponding installa-

tion position will result in incorrect LED displays on the front of the U 100 base unit (see section

"Device description"). Furthermore, the correct position cannot be displayed on the web

browser user interface.

You can now install the backplane in the base unit. To do so, proceed as follows:

Figure 3: Installing the backplane in the base unit

ASK

When the U 100 base unit is in its delivery state, the three installation slots for the backplanes are

covered by dummy plates (see figure 3, above). Start by removing the Phillips-head screws [1] and

[2] from the dummy plate at the required installation position (left, middle or right) and remove the

dummy plate.

You can now see the two connection cables for the selected slot (power supply and signal cable).

Connect the cables to the backplane as shown in figure 3 (above).

Now carefully insert the backplane into the slot of the U 100. Make sure the cables are not jammed.

You can push the backplane into the housing by applying light pressure.

ESULT

The backplane is now connected and installed. Once installed, it should correspond to the figure at the

left.

NOTE

You can learn how to connect a plug-in module to your PC or laptop by reading

the operating manual for the respective signal converter.

Version 04-2018A

Page 9