Flying Industry Development 0020027 Quick Manual - Page 2
Browse online or download pdf Quick Manual for Remote Control Flying Industry Development 0020027. Flying Industry Development 0020027 5 pages. Rf wireless receiver
Print Page
Setting limit control modes:
1) When the receiver is in the status of LEARNING, if you press button
mode.
You can connect two normally open limit switches to limit control terminals according following circuit diagram 3, then you can use limit switches to
stop the motor.
When motor rotates in forward direction, if you connect limit switch "UP", the motor will stop automatically.
When motor rotates in reversal direction, if you connect limit switch "Down", the motor will stop automatically.
2) When the receiver is in the status of LEARNING, if you press button
closed mode.
You can connect two normally closed limit switches to limit control terminals according following circuit diagram, then you can use limit switches to
stop the motor.
When motor rotates in forward direction, if you disconnect limit switch "UP", the motor will stop automatically.
When motor rotates in reversal direction, if you disconnect limit switch "Down", the motor will stop automatically.
Manual buttons:
▲
Press manual button
of the receiver: The motor rotates in the forward direction.
■
Press manual button
of the receiver: The motor stops.
▼
Press manual button
of the receiver: The motor rotates in the reversal direction.
■
Press manual button
of the receiver: The motor stops.
Installing external manual switches:
You can connect three external manual switches (normally open type) to manual control terminals according following circuit diagram 3, then you can
use external manual switches to control the motor.
When press manual switch "UP": The motor rotates in the forward direction.
When press manual switch "Stop": The motor stops.
When press manual switch "Down": The motor rotates in the reversal direction.
When press manual switch "Stop": The motor stops.
How to pair the transmitter to the receiver:
1) Press the setting button of the receiver for 5~6 seconds until signal LED on the receiver flashes 3 times, then release the setting button. The
receiver enters into status of LEARNING.
2) Press any button on transmitter within 5 seconds. If signal LED flashes 5 times, it means learning is successful.
3) The receiver can learn several transmitters with different codes.
Delete all transmitters:
We have learned the transmitter to the receiver. If you don't want the receiver to work with the transmitter, you can delete all codes of the transmitters
which are stored in the receiver.
Operation: Pressing the setting buttons of the receiver for 12~15 seconds until the signal LED on the receiver flashes 5 times, then release the
setting button. That means all stored codes have been deleted successfully.
▲
▼
SHENZHEN FLYING INDUSTRY DEVELOPMENT CO.,LTD
http://www.carymart.com
E-Mail: [email protected]
■
or the left button
of the transmitter, the limit function is normally open
■
or the right button
of the transmitter, the limit function is normally