Flying Industry Development S1UD-DC06 Quick Manual - Page 2

Browse online or download pdf Quick Manual for Remote Control Flying Industry Development S1UD-DC06. Flying Industry Development S1UD-DC06 2 pages. Rf wireless remote control radio controller with delay time function / transmitter & receiver
Also for Flying Industry Development S1UD-DC06: Quick Manual (3 pages)

Print Page

Setting control mode Latched: Connect Jumper-1 and Jumper-2.

Control mode Latched: Press -> On, other relays Off; Press another button -> Off.

Press button 1: Turn on the relay (connect B and C, disconnect A and B)

Press button 2: Turn off the relay (disconnect B and C, connect A and B)

If you set delay time, such as 10 seconds:

Press button 1: Turn on the relay (connect B and C, disconnect A and B)

After 10 seconds, Turn off the relay automatically (disconnect B and C, connect A and B). Or press button 2 w ithin 10 seconds: Turn off the relay

immediately.

Delay time setting function:

Press the setting button, the LED off, that means enter into the delay time setting mode.

Then you can set delay time through pressing the learn button. Press the learn button, LED w ill flash once, that means the delay time increase 1

seconds, i f you want to delay 30 seconds, you need to press the learn button w i t h 30 times.

You can set longest delay time to 99 seconds.

Press the setting button again, the delay time w hat you have set w ill be preserved forever even if you turn off power. After the delay time is

preserved by the system, LED w ill flash 3 times, the system w ill quit the delay time setting mode.

For example, w hen you use this receiver to control one lamp, and you already set 30 seconds delay time, you can press button 1 to turn on the

lamp, and the lamp w ill turn off automatically after 30 seconds. If you don't need the delay function, you should clear the delay time.

Clear delay time:

If you don't want to set the delay time, you can operate as follow i n g:

Press the setting button and enter into the delay time setting mode, the delay time w hat you have set will be cleared automatically.

Press the setting button again, LED w ill flash 3 times, the system w ill quit the delay time setting mode.

Note:

We have learned remote control to the receiver. I f you don't want the recei v er to work with the remote control, you can delete all codes of remote

control s , which are stored in the receiver.

Operation: Press and hold the learn button of receiver until LED begin flashes slowl y ; release the button, LED keeps slow flash. That means all

stored codes have been deleted successfully.

Learning the button of remote control:

1) Press the learn button of receiver, LED off. The receiver enters into status of LEARNING.

2) Press any one button on remote control. If LED flashes 3 times and turns off, it means learning is successful.

3) When receiver is in the status of LEARNING, you should learn the remote control within 10 seconds, or the receiver w ill quit the status of

LEARNING after 10 seconds.

4) The receiver can learn 16 remote controls w ith di f ferent codes.

Interior Analogue Circuit

Setting Button

Antenna

LED

Application Circui t

DC0~28V/ AC110~240V

A, B=Norm ally Closed; B, C=Norm ally Open.

Learn Button

Jumper

Relay

Lamp

Power supply

SHENZHEN GUIYUAN INDUSTRY DEVELOPMENT CO.,LTD

Http://www.carymart.com

Application: For DC12V motor or lamp