flying Thinz Mad 3D Taco Instruction Manual - Page 8
Browse online or download pdf Instruction Manual for Toy flying Thinz Mad 3D Taco. flying Thinz Mad 3D Taco 14 pages. An all out 3d fun fly plane
Radio & Control Preparation
Attach the control horns to your servos and attach the
included Mini EZ Connectors to the outer most hold on the control
horn as shown above.
Cut down the carbon fiber rods to 8".
Create two wires with a 90 degree bend at 5 1/2". The wire
should run 5 1/2" then turn 90 degrees. Make sure the bend is no
more than a 1/4" long.
Create two wires with a 90 degree bend and a Z bend on the
other side that is 4 1/2". The length of the wire before any bend
should be 4 1/2".
Finally create two wires with a Z bend bend at 4". The wire
should run 4" then turn into a Z bend.
Drill a 1/16" hole, 1" from each end of the carbon rod. Make
sure the holes line up as much as possible with each other.
8
Cut down the heat shrink tubing to 1 1/2" pieces. Place
the tubing over the carbon fiber rod and insert the 90 degree bend
into the drilled hole. Using a hot air gun or lighter, heat the tub-
ing until it wraps tightly around the rod and wire. Add a few
drops of CA into the opening of the rod for added strength.
One side should use the wire that has the Z bend, while the other
end, should just have the straight wire as shown in the image
above.
Radio Installation
Install the aileron servos on the bottom of the wing 5" from
the side of the fuselage. Use double sided tape or hot glue to hold
the servo in place. Repeat on the other side. Make sure to clean
all surfaces with alcohol before applying your double sided tape.
Tip: FlyingThingZ recommends using double sided tape over
hot glue. During extremely hot days, we have experience ser-
vos coming loose during flight.