flyingwings WRA-SPEC WING Manual - Page 5

Browse online or download pdf Manual for Toy flyingwings WRA-SPEC WING. flyingwings WRA-SPEC WING 9 pages.

Print Page

STEP

Cut FPV slots

Top

It's laminating time !

We leave this step up to you, and if you are not sure about laminating, check this video

out courtesy of Matt www.youtube.com/watch?v=U6hD7CeWEt4

My personal choice is to install as much equipment as possible like servos , RX, fpv ,

and all cables before laminating, so I don't have to cut into the laminate after. This does

mean that whilst laminating, I have to make some cuts to allow the servos through. We

leave this up to you. We recommend 75mic laminate, around 2 metres is adequate.

STEP

Sand the front edge of each elevon as shown, as

a pair.

Then cover the elevon in tape.

MAKE A HANDED PAIR !!!!