AIR HANDLE AHR User Manual - Page 12
Browse online or download pdf User Manual for Industrial Equipment AIR HANDLE AHR. AIR HANDLE AHR 14 pages. Excluding gripper
Print Page
_________________________________________________________________________________________________
Extended information about service/maintenance can also be found in these enclosures:
Enclosures
Reference manual for AH system Pnnn V1.0
Customer specification AHR
User manual for gripper
Schematic for gripper
TROUBLESHOOTING
NOTE! Wrong or maladjusted settings can cause serious damage to both people and equipment. Actions that require
modifications to the equipment can only be done by authorized personnel. Beware of electrical safety, working with
equipment that is connected to the power line must be performed by an authorized electrician.
Error
Possible cause
Failure of power supply
The hoist do not start at
all
Failure of air supply
No stroke
Error of signal between handle and
controller system
The safety belt has been activated
Error of signal between handle and
Jerky liftning motion.
controller system
Leakage in signal between handle and
Hoist slows down.
controller system
If errors can not be resolved by this troubleshooting guide, contact Air Handle or representative for service/repair. To
be able to provide faster service, please refer to this manuals order number User manual AHR V1.0.docx.
_________________________________________________________________________________________________
Air Handle e-p AB
Telephone
Cedersdalsvägen 6 D
186 40 VALLENTUNA
Sweden
+46 (0)8-511 873 02
Action
Check that the display of the hoist's left side
is showing digits, check that the circuit
breaker is on, check fuses.
Check compressed air connection, wrinkles
on tubing, check that there is pressure in
the air supply system
Check tubing between handle and controller
system
Run the hoist all down, you may help pull
some wire out by hand – the safety belt will
no release its lock, give gentle signal upward
Check the bar indication on the hoist's left
side. Up signal – bar at upper position.
Down signal – bar at lower position. Bars
in middle – handle in neutral position, no
signal
Check tubing between handle and
controller system, check the membrane
for damages
Fax
E-mail
+46 (0)8-511 873 04
User manual - Side 12 of 14
AHR excluding gripper
User manual AHR V1.0.docx
Website
http://www.air-handle.se