Cold Point CNC series Installation, Operation And Maintenance Manual - Page 2

Browse online or download pdf Installation, Operation And Maintenance Manual for Air Conditioner Cold Point CNC series. Cold Point CNC series 10 pages. Remote condensing unit

Print Page

CONSUMER/USER INFORMATION

SECTION:
Thank you for choosing Cold Point Corp. products! Our
goal is to make sure you remain pleased with your
decision to purchase Cold Point Corp. products. If you
are in need if assistance that is not available or
provided by your local installer/contractor feel free to
give us a call, write us, or e-mail us at:
Cold Point Corp.
7500 Cold Point Dr.
Rome, NY 13440
Phone: 315.339.2331
FAX: 315.339.2358

OPERATING INSTRUCTIONS:

CNC air conditioners are designed to provide comfort
cooling at outside temperatures above 60 degrees.
Operating the air conditioner below 60 degrees may
cause unit failure and will void the Warranty. If you
have need for cooling at lower outdoor temperatures a
'low ambient cooling' option is available. Contact your
local contractor or call the factory.
TO OPERATE:
1). Set the switch on your wall thermostat to the 'cool'
position.
2). Set the desired temperature you want to maintain by
moving the temperature setting lever or dial on your
thermostat. If the room is warmer than the setting, the
unit will turn on and begin to blow cool air after a few
minutes. Note that a warm humid room or building
may take several hours of continuous operation to
cool to the thermostat set point the first time. Once
the set temperature is reached the unit will cycle on
and off.
3). Set the 'Fan' switch on the thermostat to 'auto' if
you want the fan to run only when cooling is needed
or to 'on' if you want continuous air circulation. The
'on' setting of the fan generally provides better
temperature control by eliminating stagnant air.
4). For energy conservation reasons you may want to
set your thermostat at a higher temperature when you
are away. Do not raise the temperature setting by more
than 5 degrees. Changing the temperature by more
than 5 degrees or shutting the unit 'off' can actually
cost more than leaving the setting at a constant
temperature.
2
5). IMPORTANT! Wait at least 3 minutes after turning
your air conditioner off before trying to restart it. This
gives the unit the time needed to stabilize before
restarting. Failure to do so may cause unit damage and
failure.
6). A properly installed and sized unit will not cycle more
than 10 times per hour. If you notice more frequent starts
call your service contractor.
MAINTENANCE:
Only simple periodic maintenance is required:
1). Change or clean the indoor unit air filter monthly or
more frequently if unusual conditions are encountered. If
you have a disposable type, throw the old one away and
install a fresh one of the same size and type. If your unit
has a washable type then vacuum and wash with soap and
water. Flush thoroughly and dry before re-installing.
2). Keep the coil in the outdoor unit clean. Periodically
flush the coil thoroughly with a garden hose. Clean away
all foreign materials such as dust, leaves, grass clippings,
papers, etc. Warning: Turn the power off first! Serious
injury or death may result if water spray is directed at live
electrical connections or power sources.
3). Yearly waxing of the exterior cabinet surfaces with a
good quality car wax will keep your unit looking new and
extend the life of the cabinet.