Dacs HeadLite2 User Manual - Page 6

Browse online or download pdf User Manual for Amplifier Dacs HeadLite2. Dacs HeadLite2 8 pages.

Print Page

8 Input Select switch

With up to four inputs connected to the unit, you can decide which headphone

amplifier output you wish to use. To select the input(s) you wish to listen to, rotate the

selector switch to the appropriate point: AB means inputs A and B on the Left and

Right output channel respectively;, AA means input A on both Left and Right, etc.

Plug your headphones in and adjust the volume to an acceptable level.

9 Input Meters

These tri colour LED meters indicate the level on the 4 busses feeding the

headphone amplifiers. They are calibrated as follows:

Green starts to glow at -24duB and is fully on at -8dBu to 0dBu

Orange starts at 0dBu and is fully on at +10dBu to +16dBu

Red starts at +16dBu and is fully on over +18dBu

For optimum performance operate HEADLITE 3 at 0dBu to +16dBu.

10 Power

This switches the power on and off, and is illuminated when AC mains is present. The

switch is connected before the fuse, so if the switch is illuminated and the unit does

not work, the fuse may be blown. The unit comes with a spare fuse in the fuse carrier

(T1A).

Clarity HEADLITE 3 is fitted with the ultra quiet regulated linear power supply as used

in the DACS Clarity MicAmp.

DACS LTD, Stonehills, Shields Road, PELAW, Gateshead, Tyne and Wear NE10 0HW

Tel: +44 (0) 191 4382500 | Fax: +44 (0) 191 4382511 | www.dacs-audio.com | [email protected]