DAELECTRONICS iCtrl-R-mini Operational Manual - Page 4

Browse online or download pdf Operational Manual for Recording Equipment DAELECTRONICS iCtrl-R-mini. DAELECTRONICS iCtrl-R-mini 8 pages. Pocket midi controller
Also for DAELECTRONICS iCtrl-R-mini: Operational Manual (8 pages), Operational Manual (8 pages), Operation Manual (8 pages)

Print Page

DAELECTRONICS iCtrl-R-mini Operational Manual

Calibration

Before you start using the Expression pedal (the pedal shall ALWAYS be disconnected/connected to the controller before energizing the controller

itself) you need to activate the "Calibration" by pressing the switch 1 in mode 1 until the rapid flashing of the LED 5.Immediately after entering the

calibration mode, depress the pedal backwards to the minimum heel setting then sweep to the maximum toe setting, this will ensure you calibrate

your pedal with the

iCtrl-R mini

the pedal can begin to communicate properly. The calibration values will be stored until the next calibration.

MODE 1

This firmware allows you to select eight banks with the up / down function operated by a long press, respectively, on switch 2 and 4. In the chosen

bank it's also possible to select eight presets for a total of sixty-four. The blinking LED will show you the bank you are on. For example, if you are on

bank 3, LED n. 3 will blink (the red one near the switch 3). So, if you are on the bank 7, LED n. 7 will blink (the blue one near the switch 3).

PRESETS SELECTION

 Switch 1 > press and release to select the preset 1 of the chosen bank

 Switch 2 > press and release to select the preset 2 of the chosen bank

 Switch 3 > press and release to select the preset 3 of the chosen bank

 Switch 4 > press and release to select the preset 4 of the chosen bank

 Switch 1 > long press and release to select the preset 5 of the chosen bank

 Switch 2 > long press and release to select the preset 6 of the chosen bank

 Switch 3 > long press and release to select the preset 7 of the chosen bank

 Switch 4 > long press and release to select the preset 8 of the chosen bank

BANK AND TUNER SELECTION

 Switch 2 > long hold to select the bank from 1 to 8 (bank up)

 Switch 4 > long hold to select the bank from 8 to 1 (bank down)

. Now pressing one of the switches of

LED 1 will blink, mode 1 will be activated and

iCtrl-R mini