Doremi JNIOR 310 Install And Setup

Browse online or download pdf Install And Setup for Server Doremi JNIOR 310. Doremi JNIOR 310 3 pages.

Print Page
Install and setup JNIOR 310
Time required 10 to 15 minutes
• The JNIOR ships with the default IP address of 10.0.0.201
• Ensure the DCP2000 is running software version 0.5.2-22SP1
Power up the unit
•
Connect 8-to-30v AC/DC (left/green LED is power ON)
•
When unit is powered up the right LED (orange) will show
that it is booting. This is an activity led.
Set the IP address with one of two methods:
•
Standard serial RS232 Male
– 115200 8N1 no flow control
– The serial cable for the JNIOR is a straight-through
wired DB-9 Male to DB-9 Female
•
RJ45 Ethernet cross over cable
– Ensure the PC you are using to set the IP address, is
in the same range as the JNIOR default IP address of
10.0.0.201
To set the IP address using RS232 and HyperTerminal and
type ipconfig <enter>
To set the IP address using Cross Ethernet and Telnet and
type registry <enter>
Login for both sessions: Login = jnior / password = jnior
Follow the on-screen instructions to setting the IP address.
Please consult the JNIOR "Getting Started Manual" for
more details on setting the IP address.
Start a Telnet session:
• Login = jnior
• Password = jnior
• Type: "registry" to enter
the set up
mode.
•NOTE: After setting the IP address to be in the range of the DCP2000, you must reboot JNIOR to 
confirm the new IP address has been implemented. To reboot, unplug the power, wait 5 sec, 
reconnect the power
Start a HyperTerminal
session:
•Login = jnior
•Password = jnior
•Type: "ipconfig" to
enter the set up mode.