DOREMIDI MPC-10 Instructions Manual - Page 4

Browse online or download pdf Instructions Manual for Media Converter DOREMIDI MPC-10. DOREMIDI MPC-10 8 pages. Midi pedal converter
Also for DOREMIDI MPC-10: Instructions Manual (9 pages)

Print Page

a. Software environment requirements: Windows 7 and above systems.

b. Select "DOREMiDi MPC-10" and click "Connect"

Pedal Number: The pedal number can be selected according to the interface that the pedal is

inserted into, display after "Connect".

d. Pedal Type: There are two types of pedals: Expression and Switch, after connecting the pedal,

click "SENSE" to get the pedal type. If the pedal is not connected to MPC-10, you can also

directly select the pedal type.

e. CHAN: Configure the channel of MIDI messages. There are 16 MIDI channels.

STATUS: Configure the MIDI message type of the pedal, including CC (continuous controller),

PC (program change), Note (note), three types.

g. DATA1/DATA2: Configure the content of the pedal MIDI message, including the following:

 When STATUS = CC, DATA1 is the CC controller number, and DATA2 is the CC controller data.

 When STATUS = PC, DATA1 is the PC serial number, and DATA2 is invalid.

 When STATUS = NOTE, DATA1 is the serial number of Note, and DATA2 is the strength of Note.

 When Pedal Type = Expression, DATA2 does not need to be configured.

h. MODE: Configure the trigger mode of the pedal, with three trigger modes: Single, Toggle, and

Reset:

 When MODE = Single, each time the pedal is stepped on, only the value of DATA2 will be sent

once.

 When MODE = Toggle, each time the pedal is stepped on, the value of DATA2 will be sent only

once. If stepped again, DATA2 = 0 will be sent.