Canon 7355 - LV XGA LCD Projector Owner's Manual - Page 37
Browse online or download pdf Owner's Manual for Projector Canon 7355 - LV XGA LCD Projector. Canon 7355 - LV XGA LCD Projector 48 pages. Canon owner's manual multimedia projector lv-7355 lv-7350
APPENDIX
When the life of the Projection Lamp of this projector draws to an end,
the LAMP REPLACE indicator lights yellow. If this indicator lights
yellow, replace the projection lamp with a new one promptly.
Allow a projector to cool, for at least 45 minutes before
you open Lamp Cover. The inside of a projector can
become very hot.
Follow these steps to replace the lamp assembly.
1
Turn off the projector and disconnect the AC plug. Allow the
projector to cool for at least 45 minutes.
2
To remove Lamp Cover, remove the screw with a screwdriver.
3
Loosen 3 screws with a screwdriver and pull out Lamp Assembly
by grasping Handle.
4
Replace Lamp Assembly with a new one and tighten 3 screws
back into position. Make sure that Lamp Assembly is set
properly. Replace Lamp Cover and tighten the screw.
5
Connect AC Power Cord to the projector and turn on the
projector.
6
Reset the Lamp Replace Counter.
Refer to "LAMP REPLACE COUNTER" on the next page .
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the
following information to the dealer.
G
Model No. of your projector
G
Replacement Lamp Type No.
LAMP REPLACEMENT
LAMP REPLACE
This indicator lights yellow
when the life of the projection
lamp draws to an end.
Replace the Projection Lamp
with a new one promptly.
For continued safety, replace with a lamp assembly of
the same type.
Do not drop a lamp assembly or touch a glass bulb! The
glass can shatter and may cause injury.
:
LV-7355 / LV-7350
:
LV-LP11
TOP CONTROL
Y
NE
US
WARNING
TEMP.
CAUTION
LAMP COVER
LAMP
SCREW
ASSEMBLY
(Service Parts No. 610 293 2751)
LAMP
REPLACE
LAMP
SCREW
HANDLE
37