Canon LV-S2 Owner's Manual - Page 36

Browse online or download pdf Owner's Manual for Projector Canon LV-S2. Canon LV-S2 44 pages. Micro-portable multimedia projector
Also for Canon LV-S2: Brochure & Specs (2 pages)

Print Page

SETTING

Power management

This function turns the Projection Lamp off when this projector

detects signal interruption and is not used for a certain period in

order to reduce power consumption and maintain the Lamp-life.

(This projector is shipped with this function ON.)

Power Management function operates to turn the Projection Lamp off

when the input signal is interrupted and any button is not pressed

over 5 minutes. This function operates as follows;

1. When any input signal is interrupted, "No signal" and the count

down display appears (for 5 minutes).

2. After counting down for 5 minutes, the Projection Lamp and the

READY Indicator are turned off. (Cooling Fans keep running.)

3. The READY Indicator starts to flash after cooling down the

Projection Lamp about for 90 seconds (Power Management

mode).

In this Power Management mode, the Projection Lamp is

automatically turned on when the input signal is connected or

the projector is operated with any button on the Top Control or

on the Remote Control Unit again.

Remote control

This projector has two different remote control codes; the factory-set

normal code (Code 1) and the secondary code (Code 2). This

switching function prevents remote control interference when

operating several projectors or video equipment together.

When operating projector in "Code 2," both projector and Remote

Control Unit must be switched to "Code 2."

To change the code of Projector;

Set the Remote control in the SETTING MENU to "Code 2."

To change the code of the Remote Control Unit;

Press both the MENU and the IMAGE buttons on the Remote

Control Unit together for over 10 seconds.

After changing the code, make sure the Remote Control Unit

operates properly.

To return to the normal code (Code 1), repeat the steps above.

NOTE : When the battery of Remote Control Unit is replaced, the

remote control code automatically returns to the normal

code (Code 1).

Lamp counter reset

This function is used to reset the Lamp Replace Counter. When

replacing the Projection Lamp, reset the Lamp Replace Counter by

using this function. Refer to page 38 for operation.

Time left until Lamp off.