Dorma CL700 Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Locks Dorma CL700. Dorma CL700 2 pages. Cylindrical leverset

Print Page

Supplementary Instructions

III. Removing & reassembling standard cylinder lever (cylinder changes)

Removal

1. Remove the outside lever by inserting

the key, turn clockwise and hold at 45°.

Using the pick, depress the lever catch

through the pick hole and remove the

lever. Remove the key. (Figure 1a & 1b)

2. Remove the lever insert and cylinder.

Reinstallation

3. Replace with new cylinder and lever

insert, and reinstall the lever insert.

(Figure 2)

Be sure the tailpiece is horizontal.

4. Press the outside lever onto the

spindle until it contacts the lever catch.

(Figure 3)

5. Insert the key into the cylinder, turn

clockwise and hold at 45°. Press the

lever fully onto the spindle until

it clicks into place. Release the

key. (Figure 3)

76002003 07/15

I. C770 - Timing instructions

TIMING INSTRUCTIONS: Install lock on door. Remove outside

lever and cylinder (for Interchangeable Core locks, leave levers in

place and remove cores and tail pieces)

OUTSIDE OF DOOR:

Rotate key spindle fully counter-clockwise.

Install cylinder and lever.

(See steps 4 & 5 in section III.)

Key spindle

Pick hole

45°

Figure 1a

Lever

Figure 1b

catch

II. Removing & reassembling interchangeable core lever

Removal

1. Insert the control key into the IC core,

rotate the key 15° clockwise, and remove

the core and tail piece from the lever.

2. Using a ﬂ athead screwdriver, retract the

lever catch inside the spindle and remove

the lever.

Reinstallation

3. Press the lever onto the spindle until it

snaps into place.

4. Install the tail piece on the core.

Insert the control key into the core,

rotate the key 15° clockwise, push the

core fully into the lever and turn counter

clockwise 15 ° (home position), and

remove the key.

IV. C701 Dummy trim installation

Tailpiece

(horizontal)

Cylinder

Lever

insert

Figure 2

45°

Figure 3

IC core lever

core

IC core lever

core

Lever catch

Single dummy trim

1. Using the pick, depress the

lever catch through the pick

hole and remove the lever.

2. Remove the rose from the

dummy mounting plate.

3. Position the dummy

mounting plate on the door with

the lever catch facing towards

the door edge.

4. Secure to the door using four

8-32 x

" combo screws.

Rose

notch

5. Push the rose onto the

location

mounting plate oriented with

the rose notch facing

downward.

6. Push the inside lever onto the

spindle until it clicks into

place.

Door

edge

Dummy

mounting

Lever

plate

catch

Rose