Dorma CL860 Installation Instructions - Page 3
Browse online or download pdf Installation Instructions for Locks Dorma CL860. Dorma CL860 4 pages. Cl800 series cylindrical lever lock.
Print Page
REINSTALLING OUTSIDE LEVER
Figure 6
Connector
CL853, CL860 (outside), CL882, CL880,and CL885
Functions
1. Align lever catch to face latch front.
2. Turn key in cylinder 45 degrees in either direction.
3. Slide lever on tube until it stops at the lever catch,
and push until the lever engages lever catch
and connector.
CHANGE/REPLACE CYLINDER
Cylinder
CONVENTIONAL CYLINDER
Removal (all functions)
1. Remove key from cylinder and pull plastic cylinder retainer from
lever, then remove cylinder.
Installation
1. Tailpiece must be in vertical postion in cylinder.
2. Insert cylinder in lever.
3. Press plastic cylinder retainer into lever until flush with base of
lever.
CL873 Function
1. Insert screwdriver in key cam slot and turn fully clockwise without
retracting latch. Now turn counter-clockwise 45 degrees. Remove
screwdriver.
2. With cylinder in lever handle, insert key and turn clockwise 45 degrees.
Slide lever on tube with tailpiece aligned properly.
3. Slightly wiggle and push until lever engages the lever catch
and connector.
4. Check lock for proper operation before closing door.
NOTE:
Use DORMA tailpieces only. Lock will NOT function with other
tailpieces. Be sure tailpiece is in a vertical orientation.
Connector
Mounting Post
Latch
Lever Catch
+
CL870 and CL860 (inside) Functions
1. Insert screwdriver in key cam slot, turn
fully clockwise. Then, turn back counter-
clockwise 90 degress and remove screwdriver.
2. Turn key in cylinder counter-clockwise
90 degrees. Slide lever on tube with tailpiece
aligned properly.and push until the lever
engages lever catch and connector.
4. Check lock for proper operation before
closing door.
Cylinder
Retainer
Tailpiece in
Vertical position
PAGE 3
Figure 7
Key Cam Slot
Correct orientation of spacer
for conversion of
7 pin tailpiece used
with 6 pin core.
INTERCHANGEABLE CORE CYLINDER
Removal (all functions)
1. Insert control key and turn clockwise, then pull on key to remove core.
Installation
CL853, CL860 (outside), CL882 and CL880 Functions
1. Insert control key in core and turn clockwise.
2. Insert tailpiece #76002027 in core
3. With control key in core, insert core fully into lock.
4. Turn key counter-clockwise and remove key.
CL870, CL872, and CL860 (inside) Function
1. Insert screwdriver in key cam slot in tube and turn fully
clockwise.
2. Insert control key in core and turn clockwise.
3. Insert tailpiece #76002023 in core.
4. With control key in core, insert core fully into lock.
5. Turn key counter-clockwise and remove key.
CL877 Function
1. Using a screwdriver, place the tip into the key cam slot and turn
counter-clockwise as far as possible.
When at the maximum counter-clockwise position, turn clockwise 90 degrees
Insert outside IC core cylinder into lever.
2. Test to see that timing is correct for both inside and outside levers.
Latch
Lever Catch
CL877 Function
1. Install inside cylinder. Any orientation in key cam
slot is acceptable.
2. Install the outside cylinder as follows:
Using a screwdriver, place the tip into the key cam
slot and turn counter-clockwise as far as possible.
When at the maximum counter-clockwise position,
turn clockwise 180 degrees. With cylinder in the
outside lever, turn key clockwise 90 degrees and
install on lever tube.
3. Test to see that timing is correct for both
inside and outside levers.
IC Core Lever
Interchangeable Core