Canor HYPERION P1 User Manual - Page 5
Browse online or download pdf User Manual for Amplifier Canor HYPERION P1. Canor HYPERION P1 7 pages.
Print Page
Basic functions of reproduction
Plug the power cord into HYPERION P1. Turn on the preamplifier with the Power Main switch, which is
located on the back panel. When you turn on the main switch, the HYPERION P1 will set into standby mode -
the red LED diode on the front panel lights up. After pressing the Power button on the front panel, the controlled
turning-on sequence gets initiated, which consists of cooling and preheating the tubes, thereby extending their
life span. The cooling cycle is also carried out when the unit is turned off. If the main switch on the back panel is
not turned off, i.e., after turning off via the button on the front panel, the 45-second countdown to cooling
without indication begins. If you turn on the unit at this time, the cooling will continue and will be indicated by a
flashing red LED. When the cooling cycle is over then the main transformer gets connected and then the slow
start-up of voltage begins.
This cycle lasts 45 seconds and then the red LED stops flashing, and an output relay connects the signal to the
input if the main power supply does not get disconnected.
You can connect both 4 and 8 Ohm loudspeakers. The amplifier has separated terminals for each type.
Guarantee conditions:
Your CANOR HYPERION P1 tube preamplifier is guaranteed against any defect in materials and workmanship
for a period of 24 months from the date of purchase except for audio vacuum tubes that are covered by warranty
for a period of three months.
The warranty only applies if an original proof of purchase and acknowledged certificate of warranty can be
furnished. The warranty covers defects in materials and labour but does not cover misuse, unauthorized
modifications, and external causes such as acts of nature.
European Community Directives
This product is designed and manufactured to comply with existing laws of the European Community. This
product is certified by a testing laboratory and bears the CE mark.
Caution!
The Waste Electrical and Electronic Equipment Directive Regulation of the European Union 2002/96/EC
governs the issue of separate waste collection.
This device may not be disposed of in the unsorted municipal waste. Devolve the appliance upon a collection
centre for recycling and disposal of electrical and electronic equipment waste. Correct disposal of waste does not
cause negative impacts on the environment and human health. You will thus contribute to the protection of the
environment.