Cansec MAP1 Configuration - Page 12

Browse online or download pdf Configuration for IP Access Controllers Cansec MAP1. Cansec MAP1 12 pages.

Print Page

IP Reset

Note: Optional method to reset IP address of MAP controller to factory default.

1. If the MAP1 controller is powered on, proceed to step 2. Otherwise, insert the

power connector into the MAP1 controller. The unit will begin the power up

sequence which takes about 30 to 40 seconds. When complete, the MAP1 controller

will beep indicating its mode e.g. First Access, Webster or CloudACS.

2. Press and hold the IP reset button (PB2) until the MAP1 controller sounds with a

continuous beep. Release the IP reset button and the MAP1 will re-boot. During

reboot the MAP1 controller resets itself to obtain an IP address automatically

(DHCP mode enabled) and erases any previous static IP address settings. Default

password will also be reset to Cansec.

Note: If a USB drive is present during reboot, the MAP1 controller will look for the file

named MAPCFG.txt and extracts IP settings parameters to configure its IP address

information accordingly. If the file is not present, the MAP1 controller will create a

template file named MAPCFG.txt with factory default parameters. If no USB drive is

present the MAP1 controller will continue with its reboot sequence.

® First Access is a registered trademark of Cansec Systems Ltd.

® Windows is a registered trademark of Microsoft Corporation in the United States and/or other countries.

MAP1 IP Configuration

Page 12 of 12

July 2021 • Rev. 1.2