Cansec VIA Installation Manual - Page 14

Browse online or download pdf Installation Manual for Switch Cansec VIA. Cansec VIA 20 pages. Universal wireless lock
Also for Cansec VIA: Installation Manual (10 pages)

Print Page

TYPICAL NET ID CONFIGURATIONS

UNIT ID: 1

NET ID: 10

UNIT ID: 2

NET ID: 10

UNIT ID: 1

NET ID:

UNIT ID: 2

NET ID: 63

DIP SWITCH "C" - DOOR CONTACT BYPASS

Switch C1 is used to indicate whether or not a door contact is connected. When set to ON (to the

RIGHT), the door contact input will be bypassed. This is the default setting. When it is OFF (to the

LEFT), the control unit expects to see a door contact connected. It is highly recommended that the

supplied door contact be installed as it allow for the detection of Forced Entry. The bottom switch

C2 is not used.

Slide switch C1 to RIGHT (ON) to disable door contact (default):

Slide switch C1 to LEFT (OFF) to enable door contact:

NOTE: See Via Hub installation manual for Net ID configurations

Figure 5: Typical Net ID Configurations

Via Wireless Lock

Installation Manual

FORCED ENTRY OUTPUT

NET ID: 10*

LOW BATTERY OUTPUT

WIEGAND

LOCK RELAY

FORCED ENTRY OUTPUT

LOW BATTERY OUTPUT

VIA

UNIVERSAL

WIEGAND

HUB

LOCK RELAY

+12 VDC FROM

ACCESS CONTROL PANEL

FORCED ENTRY OUTPUT

NET ID: 63*

LOW BATTERY OUTPUT

WIEGAND

LOCK RELAY

FORCED ENTRY OUTPUT

LOW BATTERY OUTPUT

VIA

UNIVERSAL

WIEGAND

HUB

LOCK RELAY

+12 VDC FROM

ACCESS CONTROL PANEL

ANY ACCESS CONTROL PANEL

DOOR 1

AC CE SS

CO NT RO L

PA NE L

DOOR 2

ANY ACCESS CONTROL PANEL

DOOR 1

AC CE SS

CO NT RO L

PA NE L

DOOR 2

Page

July 2018 • Rev. 1.3