Akytec ITP15 User Manual - Page 4

Browse online or download pdf User Manual for Measuring Instruments Akytec ITP15. Akytec ITP15 10 pages. Led bargraph indicator

Print Page

3 Intended use

The device may only be used in the manner described in this user guide, properly installed

and in accordance with the specification. Damages caused by disregarding the instructions

of this manual are without liability. Non-observance of the safety guidelines may result in

damage to the device and injury to personal.

Improper use

Any other use is considered improper. Especially to note:



The device may not be used for medical devices that sustain, monitor or otherwise affect

human life or health.



The device may not be used if the environmental conditions (temperature, humidity etc.)

are not within the limits indicated in the specification.



The device may not be used in potentially explosive environment or in an atmosphere

with chemically active substances.

4 Functions



Displays process value



Displays signal overrange



Adjustable alarm limits



Configurable output signal



Displays error when sensor break or short circuit.

5 Installation

Improper installation can cause serious or minor injuries and damage the device.

CAUTION

Installation must be performed only by fully qualified personnel.

The device is designed for horizontal or vertical panel mounting in a borehole of Ø22.5 mm

(see Appendix A for dimensional drawings).

Carefully position the supplied gasket on the display rear surface. Insert the cylindrical body

of the device into the borehole and tighten the nut from the rear side of the panel.

5.1

Switch on the power supply only after the wiring of the device has been completely

CAUTION

performed

Switch off the device before checking the sensor and connection lines.

►

NOTICE

For circuit integrity check use only the measuring device with the output voltage max.

4.5 V to prevent the device damage. Disconnect the sensor in case of higher voltage.

►

Signal cables should be routed separately or screened from the supply cables.

NOTICE

Only a shielded cable may be used for signal lines.

Do not use wire end ferrules to connect

To connect fine-stranded wire, tin the wire

akYtec GmbH · Vahrenwalder Str. 269 A · 30179 Hannover · Germany Tel.: +49 (0) 511 16 59 672-0 ·

Wiring

Fig. 5.1 Wire preparation

stranded wires.

end.

Fig. 5.2 Connecting the wire to the terminal

To connect solid wire, push the wire into the

terminal.

To connect stranded wire, press the release

lever and push the wire into the terminal.