Canyon Cottage Colors 3682802P Assembly Instructions Manual - Page 3
Browse online or download pdf Assembly Instructions Manual for Indoor Furnishing Canyon Cottage Colors 3682802P. Canyon Cottage Colors 3682802P 16 pages. Bunk bed
Print PageALIGN THE PRE-DRILLED HOLES IN LONG PART OF METAL HOOKS BRACKETS ( O ) WITH THE PRE-DRILLED HOLES IN THE LADDER ( N ), SECURE WITH 1" SCREWS (P ) USING
(NOT INCLUDED)
PHILLIPS HEAD SCREWDRIVER
SHORT PART OF METAL HOOKS ON TOP GUARD RAIL TO SECURE THE LADDER
FIG.13
1.- ASSEMBLE FULL BOTTOM HDBD & FTBD, USING ONE HEADBOARD (T), ONE FOOTBOARD (U) AND TWO SIDE RAILS (F).
2.- INSERT TWO CROSS DOWEL NUTS (I) IN ACCESS HOLE INSIDE THE SIDE RAIL, ALIGN THE CROSS DOWEL NUT, MAKE SURE THE GROOVE IS HORIZONTAL, SEE FIG.A
3.- ATTACH THE HDBD AND FTBD TO SIDE RAILS, INSERTING TWO FLAT HEAD BOLTS (H) INTO THE HEADBOARD & FOOTBOARD HOLES, USE THE 5MM ALLEN WRENCH (J) TO
TIGHTEN BOLTS UNTIL SECURE,
4.- PLACE FOUR SLATS (Q) ON SIDE RAIL CLEATS, ONE SLAT IN BOTH ENDS, PUSH THE SLAT AGAINST THE BED END POST
DISTANCE FROM THE END SLATS, THEN EACH SLAT MUST BE FASTEN WITH TWO 1 1/4" SCREWS (R),
5.- INSERT THE CASTER (V) INTO BOTTOM CORNERS OF THE HEADBOARD & FOOTBOARD,
6.- WHEN PURCHASING FULL BOTTOM HEADBOARDD & FOOTBOARDD, WE RECOMMEND TO USE ONE RAIL CAP (D)
7.- TO INSTALL THE RAIL CAP, PLACE IT AS
8.- ROLL THE FULL BOTTOM HDBD & FTBD, AND PLACE IT BETWEEN LOFT DRESSER AND 1 PC BUNK BED END AS SHOWN IN
HORIZONTAL
FIG.A
FIG.1
REV 04 05/08/2019
CANYON FURNITURE COMPANY
LADDER ASSEMBLY INSTRUCTIONS
SEE FIG.C
,
MAKE SURE ALL BOLTS
FULL BOTTOM HDBD & FTBD AND RAIL CAP ASSEMBLY INSTRUCTIONS
SEE FIG.1
FIG.F
, MAKE SURE THE RAIL CAP IS INSERTED ALL THE WAY DOWN ON THE SIDE RAIL AND PUSHED TO THE HEADBOARD, (FIG.4)
YES,
GROOVE
MAKE SURE ALL BOLTS
ARE TIGHTENED
COMPLETELY
NO
AND HOOK THE LADDER IN THE PROPER POSITION, ADJUST AND ALIGN THE PRE-DRILLED HOLES IN THE
SEE FIG.D
, AS SHOWN IN
ARE TIGHTENED
COMPLETELY
FIG.C
SEE FIG.E
FIG.B
FIG.E
PAGE 3 OF 4
FIG.13
K.- (1) 3 DRAWER NIGHT STAND
FIG.D
CASTER TWIN BED BOX ( 90-707,90-709 )
M.- (1) CASTER BED HEADBOARD
N.- (1) CASTER BED FOOTBOARD
O.- (4) METAL CASTER SOCKET
J.- (6) 1 1/4" SCREW
(FIG.B)
AND TWO SLATS IN THE MIDDLE AT EQUAL
SEE FIG.2
SEE FIG.3
(28-735)
,
IN FIGURE 13.
FIG.2
KIS01179-2A