Advance Appliances ECB 210 Installation And User Manual - Page 4

Browse online or download pdf Installation And User Manual for Boiler Advance Appliances ECB 210. Advance Appliances ECB 210 17 pages. Electric combination boiler

Print Page

INTRODUCTION

The Advance Electric Combination boiler is perfect for modern all electric

apartment dwellers who prefer the comfort of wet central heating systems

and mains pressure hot water for powerful showers and quick bath ﬁlling.

The unit is supplied for use with a vented (open) central heating system and

also provides mains hot water. It should be installed so the top of the unit is

500mm above the top of the highest radiator. It can easily be converted to a

sealed system operation, please see page 11. It utilises off peak electricity for

economy in use and is pre-wired and pre-plumbed for ease of installation.

Two programmers are ﬁtted to the unit, a timer for off peak (usually

overnight) electricity tariffs and a programmer for switching the central

heating on and off during the day. The central heating programmer/room

thermostat is wireless and can be used without the need for additional

wiring.The end user must set both of these.

There is sufﬁcient hot water from an overnight charge for a shower and

a bath. A second immersion heater is ﬁtted which should be wired to a

switched spur for hot water boost. If there are days when your hot water

needs increase this can be manually switched.

The product meets the HWA thermal store speciﬁcation and parts G and L

of the Building Regulations.

The lower part of the store is dedicated to central heating. A 6kw

immersion heater is ﬁtted for this purpose, and can be used in systems up

to four or ﬁve radiators. During start up periods the energy stored in the

lower part of boiler is ready for immediate use. If the water in the

radiators falls overnight to 20°C, for example, the 6kw heater is adequate

for demand of up to 10kw when ﬁrst switched on in the day.

Note: Electrical repairs must only be undertaken by the manufacturer,

service agent or similarly qualiﬁed person in order to avoid a

hazard.