1B PARAGON Use And Care Manual - Page 9

Browse online or download pdf Use And Care Manual for Cooktop 1B PARAGON. 1B PARAGON 12 pages.

Print Page

Cleaning the Cooktop Glass

To maintain and protect the surface of your glass cooktop, follow these steps:

1. Before using the cooktop for the ﬁrst time, clean it with CERAMA BRYTE

Cleaner. This helps protect the top and makes cleanup easier.

2. Apply a few drops of CERAMA BRYTE

3. Use a paper towel or CERAMA BRYTE

4. Use a dry cloth or paper towel to remove all cleaning residue. No need to rinse.

NOTE: It is very important that you DO NOT heat the cooktop until it has been cleaned

thoroughly. DO NOT use the cooktop cleaner on any plastic pieces on the cooktop.

Metal Marks and Scratches

1. Be careful not to slide pots and pans across your

cooktop. It will leave metal markings on the cooktop

surface.

These marks are removable using the CERAMA

BRYTE

Ceramic Cooktop Cleaner with the CERAMA

BRYTE

Cleaning Pad for Ceramic Cooktops.

Damage from Sugary Spills and Melted Plastic

Special care should be taken when removing hot substances to avoid permanent damage of the glass surface. Sugary

spillovers (such as jellies, fudge, candy, syrups) or melted plastics can cause pitting of the surface of your cooktop

(not covered by the warranty) unless the spill is removed while still hot. Special care should be taken when removing

hot substances. When cleaning, be sure to use a new, sharp razor scraper.Do not use a dull or nicked blade.

1. Turn o cooktop. Remove hot pans.

2. While wearing an oven mitt:

a. Use a single-edge razor blade scraper to move

the spill to a cool area on the cooktop.

b. Remove the spill with paper towels.

Burned-On Residue

NOTE: DAMAGE to your glass surface may occur if you

use scrub pads other than those recommended.

1. Allow the cooktop to cool.

2. Spread a few drops of CERAMA BRYTE

Cooktop Cleaner on the entire burned residue area.

3. Rub the residue area with a paper towel, applying

pressure as needed.

* For Heavy, Burned-On Residue:

Use a single-edge razor blade scraper at approximately a 45° angle against the glass surface and scrape the soil.

It will be necessary to apply pressure to the razor scraper in order to remove the residue. A er residue is removed,

follow steps above.

Ceramic Cooktop Cleaner directly to the cooktop.

Cleaning Pad to clean the entire cooktop surface.

2. If pots with a thin overlay of aluminum or copper

are allowed to boil dry, the overlay may leave black

discoloration on the cooktop.

This should be removed immediately before heating

again or the discoloration may be permanent.

NOTE: Carefully check the bottom of pans for roughness

that would scratch the cooktop.

3. Any remaining spillover should be le until the surface

of the cooktop has cooled.

4. Don't use the cooktop again until all of the residue

has been completely removed.

NOTE: If pitting or indentation in the glass surface has

already occurred, the cooktop glass will have to be

replaced. In this case, service will be necessary.

Ceramic

Ceramic Cooktop

Clean your cooktop a er each

spill. Use CERAMA BRYTE

Ceramic Cooktop Cleaner.