Dafra DNPB328 Operation Manual - Page 5

Browse online or download pdf Operation Manual for Tools Dafra DNPB328. Dafra DNPB328 10 pages. Rivnut tool
Also for Dafra DNPB328: Operation Manual (10 pages)

Print Page

DNPB328 Operation Manual

It is recommended to set a trial rivnut to ensure the correct stroke setting. The illustration below

shows the results of correctly and incorrectly set stroke.

If the stroke is set too long or there is a fault with the rivnut itself, it's possible that the rivnut may not

be released from the tool mandrel (#1) after setting.

To release the tool from the damaged rivnut, first loosen the knurled cover (#12), slide away the

sleeve (#56), then insert a 2.5mm diameter Allen-key through the stroke adjusting window into the

gap along the flat side of the nose pedestal (#10) and spring house (#5) which is positioned to the

side in the stroke adjusting window. Be sure that the nose pedestal (#10) and spring house (#5) are

secure with each other then hold on to the nose pedestal (#10) and the Allen-key clockwise. This

will also turn the mandrel (#1) clockwise therefore releasing the rivnut as shown:

TOOL OPERATION FOR SETTING RIVNUTS

1) After completing your start-up preparations and setting your stroke correctly, turn your rivnut

once onto the tool mandrel (#1) then apply light pressure to the end of the rivnut - the mandrel

(#1) will automatically thread itself into the rivnut. Place the mandrel (#1) with rivnut attached

into your pre-drilled work piece hole.

2) Pull the tool trigger (#53) to set the rivnut in its position on work piece.

3) After setting the rivnut, release the trigger (#53). The mandrel (#1) will turn anti-lock wise

and release the tool from the set rivnut. If the tool is still not released from the set rivnut,

press the button at the back of compressed spring pedestal (#21), then the tool will be

released.

All manuals and user guides at all-guides.com