Dot-Spot clarios flex beam Operator's Manual - Page 12

Browse online or download pdf Operator's Manual for Landscape Lighting Dot-Spot clarios flex beam. Dot-Spot clarios flex beam 15 pages.

Print Page

Assembly

Connection

The clarios is supplied with DC power and dimmed via a separate PWM signal (pulse width mod-

ulation). A PWM signal (S-PWM) is required for each light color. The PWM input has the following

characteristics:

PWM line connected to ground (-)

PWM line open

PWM line connected to operating voltage (+)

PWM frequency = 0 to 1,000 Hz

The switching point of the luminary between on and off for the PWM level is not defined: Ideally it

should be worked with a switching impulse between ground and open contact or optionally with an

impulse between ground and operating voltage. A PWM signal differing from the operating voltage

is not allowed.

Free cabling

The connect is made according to the assignment tables. The connection must be carried out ac-

cording to the required IP classification.

clarios white / monochromatic

Wire color

red

blue

black

Attention:

In case the luminary is used without the dimming function, the PWM line (wire for the

PWM signal) must be connected to ground (-). Otherwise the LED remains off.

Connection diagram of the clarios white / monochromatic without dimmer

See respective drawing in the middle of this manual (p. 14+15).

Connection diagram of the clarios white / monochromatic with dimmer

See respective drawing in the middle of this manual (p. 14+15).

clarios flex beam RGB

Wire color

white

red

green

blue

black

LED on

LED off

Assignment

+ 24 Volts

S-PWM

ground (-)

Assignment

+ 12

red S-PWM

green S-PWM

blue S-PWM

ground (-)

Assembly

Attention:

The cable of the clarios flex beam RGB features a wire which is not used (brown or gray).

Normally, the wire is shortened ex works and should not be connected.

Connection diagram of the clarios flex beam RGB

See respective drawing in the middle of this manual (p. 14+15).

clarios flex beam RGBW

Wire color

white

red

green

blue

brown

black

Connection diagram of the clarios flex beam RGBW

See respective drawing in the middle of this manual (p. 14+15).

M12 plug and cabling system

The connection of the clarios versions with M12 connector is quite simple, either with or without

dimming function. Plug the connector of the luminary in a free socket of the M12 cabling system.

The M12 cabling system is coded in a way to avoid wrong wiring or failures.

Please plan the components required for the electrical installation (power supplies, distributors,

extensions and plugs for unassigned M12 sockets) according to the sales documentation of the

M12 cabling system before placing an order.

Assignment of the M12 connector system

Pin number

Wire color

M12 plug

(if plug is pinched off)

brown

white

blue

black

green/yellow (gray)

Setting the flex beam (clarios flex beam only)

The clarios flex beam is provided with an adjustable lens with which the beam angle can be

changed between 10° and 45° (half beam angle, FWHM) after installation. Ideally the beam angle

is set in the dark with the cold, but switched on luminary.

Assignment

+ 12 Volts

red S-PWM

green S-PWM

blue S-PWM

white S-PWM

ground (-)

5-pin plug clarios

white / monochromatic

flex beam RGB

24 V +

red S-PWM

24 V +

green S-PWM

S-PWM

12 V +

Masse

blue S-PWM

ground