Dotronix DOT-X Series User Manual - Page 4

Browse online or download pdf User Manual for Remote Control Dotronix DOT-X Series. Dotronix DOT-X Series 12 pages. Handheld addressable remote controls

Print Page

TO ACTIVATE MENUS AND CONTROLS

NOTES

Stand in front of the unit (monitor) and aim the remote at the InfraRed

(IR) receiver located on the upper left corner of the unit. Press and hold

the ENTER key on the remote for several seconds (typically 6 to 8

seconds).

The following on screen display (OSD) will appear.

MODEL M by DOTRONIX

TO ACTIVATE MENUS AND CONTROLS

KEY IN SECURITY CODE:

THEN PRESS ENTER KEY

The factory set security code is 5432. You can change this code at any

time. Refer to a later section of this manual titled CHANGING SECU-

RITY CODE AND UNIT NUMBER. At this point key in the security code

5432. As each number is pressed, an x will appear after the KEY IN

SECURITY CODE: line. If you miss-key a number the x's will disappear

allowing you another chance to enter the code. When the correct code

is entered, press the ENTER key.

The following on screen display (OSD) will appear.

TO ACTIVATE THIS SET KEY IN 01

KEY IN SET #:

All units are shipped from the factory programmed as unit # 01. For

multiple unit installations, you will want to change the unit number of all

but one unit to other numbers. Typically the units are numbered in

sequence from 01 upward. The DOT-X SERIES HARC will accept unit

numbers up to 99. (If you need more than 99, consult the factory for a

special program.) At this point, key in 01, the numbers will appear after

the colon. If you miss-key the number, simply key in the desired num-

ber, the new number will replace the miss-keyed number. When you are

satisfied with the number, press the ENTER key.