Baumer 09 Series Operating Instructions Manual - Page 7
Browse online or download pdf Operating Instructions Manual for Accessories Baumer 09 Series. Baumer 09 Series 11 pages. Ultrasonic sensors rs-232
Print PageTeach-in of Sde Y
Write two Byte
N
(identification)
Read two Byte
O
(identification)
Get
V
configuration
Set
U
configuration
Single
M
measurement
Start of
P
permanent
periodical data
output
Bedienungsanleitung_Series09-US_RS232_V1_e.doc
26.03.2013 14:43:00/tof
{0Y}
{0YXßß}
{0Nxx}
{0Nxxßß}
{0O}
{0Oxxßß}
{0V}
{0V........ßß}
{0U..........}
{0U........ßß}
Measuring
{0M}
{0MXYxxxxßß} XYxxxx
{0P}
{0Pßß}
X
Reads and stores far limit Sde
A: Teach-in successful
B: No object within measuring
range → basic setting for the
sensitivity the currently set
sensitivity level
xx
Write two Bytes with any content.
The sign must not be }.
xx
Read two Bytes stored
Retrieves actually saved
configurations:
Measuring mode (absolute, relative)
Output format (Binary, ASCII)
Sensor sensitivity (Sensors with
beam columnator)
Number of averagings
Temperature compensation on, off
P-code
SW document number
SW version
Identification (2 Byte)
See chapter „Commands explained
in detail"
Configuration of sensor with a
command:
Measuring mode (absolute, relative)
Output format (Binary, ASCII)
Sensor sensitivity (Sensors with
beam columnator)
Number of averagings
Temperature compensation on, off
See chapter „Commands explained
in detail"
X=1→Object within sensing range
X=0→Object not within sensing rg.
Y=1→Echo width big
Y=0→Echo width small
xxxx Measured value in sensor
units (0...4095) or in 0.1mm steps
See chapter „Commands explained
in detail"
Provided ASCII has been selected
the response is identical to the
command „M"
See chapter „Commands explained
in detail"
7/11
Baumer Electric AG
Frauenfeld, Switzerland