Doug Fleenor Design Preset 10 Architectural Owner's Manual - Page 7
Browse online or download pdf Owner's Manual for Control Unit Doug Fleenor Design Preset 10 Architectural. Doug Fleenor Design Preset 10 Architectural 8 pages.
Print Page
4. Upon releasing the PRESET SELECT button, the red LED will no longer flash. This indicates
recording is complete.
Repeat steps 1 through 4 until you have recorded as many presets as required, up to ten total.
RECORDING PRESET CROSSFADE TIME
A crossfade is a fade where the new preset levels entirely replace the previous levels. Each of the ten
presets can have its own unique crossfade time. Crossfade times default to two seconds.
Note:
Crossfade times range from a minimum of 0 seconds to a maximum of 999 seconds (16 minutes and
39 seconds).
Crossfade times cannot be set while the Preset 10 is locked out (red LED is illuminated).
To enter a crossfade time:
1. Disconnect the Preset 10 from any DMX512 source.
2. Press the button of the preset you wish to edit. The green preset indicator LED will illuminate.
3. Using a small blunt object (e.g. paper clip), depress the TIME SETTING MODE recessed button
located adjacent to the yellow LED indicator. The green LED indicator adjacent to the preset you
selected to edit and the yellow time LED will now flash. You will have ten seconds to set the
crossfade time. If you decide after depressing the TIME SETTING MODE button that you do not
wish to make an edit, simply wait ten seconds or depress the TIME SETTING MODE button a
second time. No changes will have been made.
4. Enter the time in seconds using the PRESET SELECT buttons. Use PRESET SELECT button 10
(OFF) to enter a zero (e.g. 120 seconds is entered by pressing PRESET SELECT button 1
followed by 2 then 0FF). The time setting command is completed by one of three methods:
a. Enter a three-digit time. The TIME SETTING MODE will exit upon the entry of the third
digit. The green preset indicator LED will illuminate steadily and the yellow time LED will
go off, indicating success. A one or two digit time may be entered with leading zeros (e.g.
five seconds as 005 or OFF, OFF, 5).
b. Enter a one or two digit time followed by pressing the TIME SETTING MODE button. The
green preset indicator LED will illuminate steadily and the yellow LED will go off,
indicating success.
c. Enter a one or two digit time and wait for ten seconds for the time setting mode to exit
automatically. The green preset indicator LED will illuminate steadily and the yellow time
LED will go off, indicating success.
Page 7 of 8