Baumer HOG 10 G Mounting And Operating Instructions - Page 15

Browse online or download pdf Mounting And Operating Instructions for Media Converter Baumer HOG 10 G. Baumer HOG 10 G 40 pages. Incremental encoder (twin encoder)
Also for Baumer HOG 10 G: Installation And Operating Instructions Manual (36 pages), Installation And Operating Instructions Manual (40 pages), Mounting And Operating Instructions (32 pages), Mounting And Operating Instructions (36 pages), Mounting And Operating Instructions (36 pages)

Print Page
Baumer HOG 10 G Mounting And Operating Instructions
5.3

Schritt 3 - Einseitig offene Hohlwelle

* Siehe Seite 7
See page 7
Antriebswelle einfetten!
Die Antriebswelle sollte einen mög-
lichst kleinen Rundlauffehler aufwei-
sen, da dieser zu einem Winkelfehler
führen kann, siehe Abschnitt 5.7.
Rundlauffehler verursachen Vibratio-
nen, die die Lebensdauer des Gerätes
verkürzen können.
MB072T2 - 11070661
53 mm
(35 mm bei/at ød = 19, 20 mm)
L
M6
*
3
Baumer_HOG11-HOG11G-T2_II_DE-EN (17A2)
5.3
Step 3 - Blind hollow shaft
*
2
ød
12 mm ≥ ø15 mm 52 mm (40-52 mm)
15 mm ≥ ø19 mm 52 mm (40-52 mm)
16 mm ≥ ø20 mm 52 mm (40-52 mm)
19 mm ≥ ø24 mm 34 mm (25-34 mm)
16 mm
20 mm ≥ ø25 mm 34 mm (25-34 mm)
Lubricate drive shaft!
The drive shaft should have as less
runout as possible because this can
otherwise result in an angle error, see
section 5.7.
Runouts can cause vibrations, which
can shorten the service life of the
device.
Montage / Mounting
Zentrierbohrung
Center hole
DIN 332-D, M6x16 mm
3 *
ød1
h6
5
L
12