Douglas Dynamics Blizzard B52092 Installation Instructions - Page 2

Browse online or download pdf Installation Instructions for Automobile Accessories Douglas Dynamics Blizzard B52092. Douglas Dynamics Blizzard B52092 2 pages. Airfoil kit

Print Page

B52092, B52093, B81041

INSTALLATION INSTRUCTIONS

WARNING

Do not exceed GVWR or GAWR, including

blade and ballast. The rating label is found on

the driver-side vehicle door cornerpost.

CAUTION

Read this document before installing the Airfoil

kit.

CAUTION

Use standard methods and practices when

attaching snowplow and installing accessories

including proper personal protective safety

equipment.

CAUTION

See your sales outlet for specific vehicle

application recommendations before installation.

Airfoil kit weight information may be found in

the Undercarriage Selection Guide.

1. Park the vehicle on a smooth, level, hard surface,

such as concrete. Lower the blade to the ground,

and turn the control to the OFF position.

Disconnect the snowplow from the vehicle, or turn

the vehicle ignition to the OFF position and

remove the key.

2. Place the Airfoil on the back of the blade with the

support legs on the outside of the center support

ribs. Slide the Airfoil forward until it comes in

contact with the front curl of the moldboard.

NOTE: The support legs may need to be stretched

to fit on the outside of the center support ribs.

mechanical, electronic, film or other distribution and storage media, without the written consent of Blizzard. Authorization to photocopy items for

internal or personal use by the Blizzard outlets or snowplow owner is granted.

Blizzard reserves the right under its product improvement policy to change construction or design details and furnish equipment when so altered

without reference to illustrations or specifications used. Blizzard or the vehicle manufacturer may require or recommend optional equipment for

snow removal. Do not exceed vehicle ratings with a snowplow. Blizzard offers a limited warranty for all snowplows and accessories. See separately

printed page for this important information. The following is a registered (

Lit. No. 29729, Rev. 00

3. Clamp the Airfoil to the blade with the Airfoil

support legs flush against the contour of the

moldboard.

Position the

Airfoil support

legs flush against

the contour

of the moldboard.

4. The holes in the Airfoil will be used as guides to

drill holes in the center support ribs. Make sure

that none of the holes in the Airfoil align with the

trip spring mount angle. If any of the holes do align

with the trip spring mount angle, adjust and

reclamp the Airfoil as necessary before drilling.

5. Using the holes in the Airfoil support legs as

guides, drill four 7/16" holes in the center support

ribs.

6. Attach the Airfoil to the blade using the supplied

3/8" x 1" cap screws, washers and locknuts.

Tighten fasteners to 31 ft-lb.

) trademark of Douglas Dynamics, L.L.C.: BLIZZARD

Printed in U.S.A.

April 15, 2007